Howdy all!
Check out my new branded gear!
www.ebay.com/s...
If you want to see my full F32 build out:
f30.bimmerpost...
Here it is at long last... the full coilover upgrade for my BMW F32 435i, but the instructions would work on almost any BMW. There is a ton of great information out there, but really couldn't find a single end to end video of how to do the installation, so reached out to Bilstein and offered to do one for them!
A kit like the B16 PSS10 gives a tremendous amount of flexibility in your setup for both ride comfort and ride height. 10 stage adjustable struts from soft to sport, and 10-30mm of drop in this kit. For me I wanted a little drop, but can't go really low due to a very steep driveway into the garage. I wanted just enough to even out the fender gap, but not enough to scrape coming or going.
Thank you to Bilstein for making a fantastic product, and I am really excited to have this in my car!
Required parts and tools:
Bilstein B16 PSS10 coilover kit
www.bilstein.c...
Floor jack and 4 jack stands
10mm, 15mm, 16mm, 17mm, 18mm, 21mm sockets
T30 torx sockets
E12, E18 reverse torx sockets
www.amazon.com...
socket extensions
Torque wrench
www.amazon.com...
15mm, 18mm, 21mm ratcheting wrench
Breaker bar
www.amazon.com...
T5, T6 alan sockets
Front collar spreader socket
www.amazon.com...
Impact driver
www.amazon.com...
Steel brush
Strut spring compressor
www.amazon.com...
Torque info:
28nm - rear strut top hat nut
56nm - front 16mm strut top hat bolts *corrected, I had 30nm before which is wrong*
44nm - front strut lower collar bolt
56nm - E18 reverse torx top hat bolt
56nm - 16mm end link hat nuts
100nm - rear strut bolt
110nm - front strut top hat nut
165nm - rear 21mm hub bolt
105lbs - wheel lugs
Nice to have:
Good headlamp
www.amazon.com...
Good lighting
www.amazon.com...
Great music - Halestorm is always good for car work!
www.halestormro...
Негізгі бет Bilstein B16 PSS10 coilover installation DIY for a BMW F3X
Пікірлер: 44