This is part 9 of a series on making a Bingham Projects Take-Down Recurve Bow. In this video, I do all the final sanding through 400 grit and then start spraying on the actual finish product. Every thing really pops once you start the spraying process.
The rest of the series can be found at the following links:
Part 1 - Overview - • Bingham Projects Take-...
Part 2 - Building the Form - • Bingham Projects Take-...
Part 3 - Building the Heat Box - • Bingham Projects Take-...
Part 4 - Gluing up the Limbs - • Bingham Projects Take-...
Part 5 - Limb Clean Up and Riser Prep - • Bingham Projects Take-...
Part 6 - Hardware Install and Limb Tillering - • Bingham Projects Take-...
Part 7 - Limb Tip Overlays - • Bingham Projects Take-...
Part 8 - Shaping the Riser - • Bingham Projects Take-...
Part 9 - Finishing the Bow - • Bingham Projects Take-...
Part 10 - Final Thoughts - • Bingham Projects Take-...
This video and description may contain affiliate links and as an Amazon Associate I earn from qualifying purchases which means that if you click on one of the products links, I'll receive a small commission.
Негізгі бет Bingham Projects Take-Down Recurve Bow Build Series - Part 9 - Finishing the Bow
Пікірлер: 9