Man I've been following the directions and trying to bleed this pump for hours. Thank you that was so easy and it works great
@carlosbonilauri8728
2 жыл бұрын
Man...you are genius! 2 hours dealing with this, foun your video ....30 secons and works like new! THANK YOU!
@N269
Жыл бұрын
Makes sense... this type of pump ain't designed to pump air.... but Guy gives a very good presentation. 👍 Same common sense can be used to bleed hydraulic presses (the ram/pump section) - get the air to the top and out the pump, then close it off. If you're good, you can bleed all air out.
@TheMetalCrafter
3 жыл бұрын
Best way to bleed a pump, thanks for posting !
@bertoberto8522
6 ай бұрын
Thank you, you helped me a lot👍👍👍
@d-louisnile6462
2 жыл бұрын
Thank you so much !
@shesamdrum50beef84
2 жыл бұрын
Thank you so much !!!!!!
@abumuslima4557
10 ай бұрын
Thank you
@Teeterkid2
Жыл бұрын
Thank you sir
@blazeandcyrus
2 жыл бұрын
My pump is holding pressure now like you show but once I connect a ram or other device to the hose, the ram will 'open' barely if I pump rapidly but normal pumping the ram will essentially extend slightly when pump is pushed down and then retract back as I lift the handle back up. Maybe someone reading this knows what I can try
@ridzwing927
2 жыл бұрын
Can you attach to a bottle jack
@rodolfovaladez420
2 жыл бұрын
how about if oil is spilled? do i follow the same procedure ?
@ferashamad8843
6 ай бұрын
Hey, I have a question while you working with the ram connected to the bumb should the fill screw be close or lose? because mine don’t work unless the fill screw is open or not tight !
@quesnoy1
6 ай бұрын
I have a floor jack that looks very similar to this. Unfortunately I accidentally loosed the rear bleed valve and hydraulic fluid spilled out. Now only one of the two jacks attached to the pump raises all the way up. How do you refill this unit with hydraulic fluid? Can you just unscrew the rear bleed valve and fill it from there?
@duleiraldaloi
2 жыл бұрын
what about if still not pumping
@molokomogale6844
2 жыл бұрын
I tried both the strategies you showed but nothing. What do think might be the problem
@shanehindley5804
2 жыл бұрын
Did you sort it?
@stevezenitram2048
3 жыл бұрын
What kind of hydraulic oil needs
@hlq2action310
Жыл бұрын
SAE 10W Monograde would be the choice. don't use ATF oil, it may damage the seals.
Пікірлер: 20