In this video I am explaining what to do if your airbag BLEW UP, or if it simply started to leak on your PTI inspection.
Capping airbags is straight forward job, I am sure that by following those instructions you will do it yourself, it almost do not require tools.
Begin by finding which airbag is leaking. Locate one or two hoses (depending on airbag position) on top of the airbag. Unscrew nuts on the hoses using wisegrips/pliers/wrench. Bend over the airlines (pinch them) to stop air going thru the lines. You can simply wrap the lines with electrical tape, or use some zipties, gorilla tape, almost anything will work.
After you did it, make sure you start your truck, release TRAILER emergency brakes, run your truck several minutes to build up air pressure on trailer. Check if all airbags pumped up, and if you have no air leaks.
Your air pressure gauge should show more than 100psi to make sure it is safe to drive to service.
If all 4 of your airbags are flat but not leaking, make sure you check this video: • What to do if your tra...
Contents of the video:
0:00 Introduction
0:25 Locating airlines
0:44 Unscrewing airlines
1:10 Capping off airbag
3:43 Making sure there is no air leaks
4:30 Please subscribe
Негізгі бет BLOWN AIRBAG? How to stop air leak on airbag? (How to cap off airbag on ANY TRUCK OR TRAILER)
Пікірлер: 10