Hello everyone and welcome back to the channel and welcome to another video with the lovely little 123d!
In this video I will be fixing the horrendous black death that is commonly associated with failure of the sealing washer at the base of the diesel injectors.
As an added bonus, and as I already have the injectors out, I figured that it would be prudent to go a few steps further and replace the aged valve cover gaskets too whilst I was in there.
As you will no doubt see, this is quite an involved process but is more than doable at home by anyone with a degree of competence and the correct tools for the task ahead.
Whilst on the topic of tools, links to all of the tools that I used in the video can be found below.
Injector Seal Removal Tool: ebay.us/X0byYP
Diesel Injector Extractor Set: Puller: ebay.us/QWDdFA
Diesel Injector Seat Cutting Tool: ebay.us/VbxxRm
The consumables used in this video are linked below:
Genuine BMW Valve Cover Gasket Set: ebay.us/sZPhqM
Genuine Bosch Copper Injector Sealing Washers: ebay.us/aME7GL
Genuine BMW Camshaft Position Sensor O-Ring Seal: ebay.us/tRuUvh
Genuine BMW EGR Bypass Pipe Seal: ebay.us/IdSXP5
Inlet Manifold Gaskets (Ignore the little Steel plug, this is only required for swirl flap removal): ebay.us/e9s7r7
All links to products are affiliate links for which I will receive a small commission on any purchase made, at no additional cost to you.
I hope that you enjoy the video.
Don't forget to like, subscribe and comment for future content from Kev's Shed!
If you wish to offer support to my channel and enable me to continue to bring you quality content then please check out my Patreon page at the following link - www.patreon.co... - Thank you.
Join me on the socials at the following links
Kev's Shed on Facebook - / 561477094498994
Kev's Shed on Instagram - / kevins_shed
Kev's Shed on Twitter - / catakev79
Негізгі бет BMW 1 Series N47 Injector Seal Replacement + Valve Cover Gasket Exchange - 1, 3 & 5 Series & X3
No video
Пікірлер: 69