Hey Sandy. Your low pressure is 6 bar and high 150 bar. That’s spot on. I would first look at getting rid of the Sulpherized DeNox cat fault. Low mileage cars are susceptible. There is a service function to regen this cat. My Indy mate usually puts a tank of VPower and a long run up the road (motorway) to clear it. It does cause running issues. But everything else there looks ok at a glance...
@sandyande
3 жыл бұрын
Thanks Darren we are going to try that very procedure tomorrow thanks for your help, Sandy
@nathanrhodes8487
Жыл бұрын
The chain guides have snapped. The chain and guides come in a set for around £100-£200 change the Exhaust vanos sensor. Clean intake vanos sensor. Replace crank position and cam position sensors and you’ll be good I swear to god. This is experience
@AntonioHuza
3 ай бұрын
How did you know ? I have now the same problem, my chain is perfectly tight but it had a little bit of play before
@crank3646
3 жыл бұрын
It is normal to have slag in the chain , depends on how the engine stops . There is no hydraulic tensioner btw the both camshaft , so it is normal . The timing chain most of the time fails around 150-200k kms on this engines . This engines have problematic injectors and coil plugs . The plugs needs to be pushed aditionally when you snap the coil plastic over them .
@sandyande
3 жыл бұрын
Thanks my friend for timing chain info u help me dodge a bullet! Cheers sandy
@D.lakmal
19 күн бұрын
Also i have this problem.if i reset adaptation valve car is working perfectly.if i try tonstart after 15min same results.i dong know why.i have a headache with this car😢
@leewood9209
Жыл бұрын
I had a long list of faults and in the end after a lot of head scratching it turned out to be no. 1 spark plug the porcelain had a crack in it… new spark plug no more problems, I also know it’s possible the seals on the vanos solenoids can cause timing issues.
@mhvdm
3 жыл бұрын
Just wanted to say the two components you pointed at @ 2:21 are not the camshaft sensors, those are the VANOS solenoids
@bryanjudefernandez2195
3 жыл бұрын
i believe the n43 does not have vanos. im not too sure tho, do correct me if im wrong, i have an e92 320ci cheer!
@i80486dx
3 жыл бұрын
@@bryanjudefernandez2195 No, @sjakkelino is right. The N43 engine does have VANOS on both camshafts. @sandy anderson is pointing at the VANOS solenoids. they act like a valve for adjusting the camshaft timing. the N43 engine also has valvetronic, which controls the amount of valve lift with an electric motor on top of the engine. You may be mistaking with the M43 engine of the first generation E46, that does not have VANOS, but a single camshaft instead. The N43 engine (E90, E91, E92) (2006-2013) does have VANOS. Great engine, will work perfect when carefully maintained. Very important is the correct spec oil and services within interval as specified by BMW.
@bryanjudefernandez2195
3 жыл бұрын
@@i80486dx ouh i see, my bad i didnt know my motor had vanos. i think the engine before 2003 models didnt have vanos, correct?
@tanoliam
3 жыл бұрын
for replacement you need to remove the valve cover by prying it with a screwdriver. remove the old and install the new membrane. close the cover.
@mikeberry304
3 жыл бұрын
Magic wand time Sandy , let him make the decision , could be normal between cams as no tensioner there , but might be worth taking cam cover off to make sure sprocket ok
@sandyande
3 жыл бұрын
Cheers mike sandy
@TheGibby3340
3 жыл бұрын
Is the Vanos actuator causing that variability in the chain tension Sandy?
@sandyande
3 жыл бұрын
Seemingly that chain slack is normal Ian! Takes me back to ford Cortina days!!!
@dermotwall78
3 жыл бұрын
Sometimes a poor quality oil filter can cause timing issues especially the o ring at the bottom of the filter housing being under sized
@sandyande
3 жыл бұрын
Thanks dermot I’ll tell him that , sandy
@ThePanditG
3 жыл бұрын
Hi, can someone tell after how many miles should the timing chain of E90/n43 should be replaced? I just got a 2010 318i with 95k miles on the clock, and am wondering if now is the time..
@muhammedali3131
3 жыл бұрын
It could be the chain tensioner
@tawfiqshreim7704
Жыл бұрын
Hey, how did you fix the code 29f2, the pressure was 445 psi then 150000 hPa, I have the same problem, I changed all the fuel parts but tell now nothing changed
@CarsExposed
3 жыл бұрын
Interesting one my friend , that chain slack seem a bit dodgy to me ...
@sandyande
3 жыл бұрын
Seemingly that’s Norma igor!
@Marcell-ux7rb
2 жыл бұрын
👮🏻♀️I'm sure the top guide broke 🤭 and that's why the chain plays like a bracelet on your hand and throws a bunch of crash codes
@kevcat8655
3 жыл бұрын
Sandy, what app have you used for this please?
@sandyande
3 жыл бұрын
I use the Autel 905 and Snap on Verus Scantools cheers sandy
@kevcat8655
3 жыл бұрын
@@sandyande Thanks mate
@user-lp8ro5lj8x
2 жыл бұрын
Have you managed to find the root cause of the rough idle and engine cutting-out in the BMW N43 engine? If so would be interesting to know what the fix was?
@sandyande
2 жыл бұрын
No car was sold
@dipindersinghsaggu5544
2 жыл бұрын
Hi, did you manage to resolve this??
@pavelhorak1888
3 жыл бұрын
I have that engine with the same engine, if you take care of your car, you will be good :-) But you have to know something more about these n53 n43 engines :))
@lucasbarnes9688
Жыл бұрын
How did you solve this problem?
@johnjohn1061
11 ай бұрын
Where I can find next part?
@royritchie4184
3 жыл бұрын
I think you need a diagnostic dice😉
@sandyande
3 жыл бұрын
Every day lol
@whyulyin
2 жыл бұрын
BMW RECALL as of today my 2008 BMW e92 320i is having a new timing chain and kit fitted by BMW as its stretched causing cold start and injection issues. If you have a recall outstanding for a "Quality Enhancement" then get in done. May save you ££££s
@sandyande
2 жыл бұрын
Thanks for information 😉
@d.d4184
3 жыл бұрын
Sometimes you are better off not getting involved. Hand the keys back and run
@sandyande
3 жыл бұрын
But I just can’t resist lol cheers sandy
@tam1381
3 жыл бұрын
Sandy tell him to buy a Toyota. Fixed.
@sandyande
3 жыл бұрын
Funnily enough his wife’s got one!!! Cheers Tam sandy
Пікірлер: 42