Really enjoying this series! Thanks Old Mechanic. 👍🏼
@TheOldMechanic
Жыл бұрын
Your welcome !
@stephanegame5688
5 ай бұрын
Very nice vidéo 🙏
@TheOldMechanic
5 ай бұрын
Thank you 👍🏻
@CoastalCruisers-yh9pu
11 ай бұрын
I may have missed something in the assembly process. Were all the bearings renewed with now before you put it back together. I assumed the large ring bearing may have been where the problem had occurred? Was the one you re installed new? Also, I noticed you didn't apply any grease to the bearings you re installed. Is that correct? I am not a mechanic but trying to learn as much as I can on my 2011 r1200gs (like yours!).
@TheOldMechanic
11 ай бұрын
Did you watched part 1 and 2 ?
@mrdin5332
Жыл бұрын
Beyond my pay grade I'm afraid. But can only hope if my rear drive needs attention the mechanic who does the job does it as well as the Old Mechanic but we all know that won't be the case.
@TheOldMechanic
Жыл бұрын
I am sure that there are good ones out there mate, 😉👍🏻👊🏻
@adelejones3746
Жыл бұрын
16 minutes in.....don't use a punch on an outer bearing race! You had the right idea with the old race. If that didn't work, use a similar sized socket.
@davidgreen424
Жыл бұрын
I don't understand how your " special " bearing puller works , It looked like it should have pushed the bearing down and out the bottom but it seemed to pull it up and I can't understand how it does that as you put it in from the top.
@mrlarsv
Жыл бұрын
Thank you for your videos. Great tech and always with a smile ;-) I had the same problem with my R1200R, but left it to a workshop - too complicated for me. But nice to see how it’s done.
@paulvanleeuwen9046
Жыл бұрын
Duidelijke instructie,kan je mij vertellen wat voor binnelagertrekker je gebruik?
Пікірлер: 13