WD-40, PB-blaster and Brownell boat stands are your best friends.
@RuggedWrench
Жыл бұрын
😂 yes we need to get some of those
@DeanFamilyAcres
Жыл бұрын
Using that ingenuity… going to be swapping trailers/boats in the near future myself. Thankfully it’s not that big of a boat.
@RuggedWrench
Жыл бұрын
I’m not sure it would have worked if the boat was much bigger 🤷♂️
@GoldenCroc
Жыл бұрын
Well done. I take it you didnt have anything to weigh the front of the trailer down with? Bags of sand, buckets with water, rocks placed in bags or just tied to it etc? Ah well, now its done. 👍
@RuggedWrench
Жыл бұрын
We ended up jacking the back of the boat up a little bit. That helped a lot
@thatslwf
Жыл бұрын
That wellcraft is a much better built boat than that junky bayliner around here we call them “trashliners”
@RuggedWrench
Жыл бұрын
I agree. But the wellcraft has a rotten transom and rotten stringers
@andrewarmstrong7310
Жыл бұрын
Bayliner...lines the bay. Haha
@AboveRioTzZ
Жыл бұрын
Any luck on getting that throttle assembly off man? Sorry for asking again just really need it to get my boat back up an going! Also need a steering cable but I can try to find one if anything lol
@RuggedWrench
Жыл бұрын
I apologize for that. We didn’t get it pulled off yet. We do have your name on it 👍
@AboveRioTzZ
Жыл бұрын
@@RuggedWrench sounds good man, sorry i've been so avid about asking. you did get my number correct? i commented it that one night but the comment got deleted a few minutes after i posted it.
@ericneering6357
4 ай бұрын
Doesn’t take much to pull a boat engine within 45 minutes. It should be out hanging in within an hour in the truck. Are you able to hit that hard? You’re doing something wrong because normally you lift up on them kick them down and they fall right off
@ericneering6357
4 ай бұрын
Doesn’t take much to pull a boat engine within 45 minutes. It should be out hanging in within an hour in the truck.
Пікірлер: 14