That is a huge tip for those of us who do our own work. Thanks for you effort.
@dgb5820
2 жыл бұрын
Great tip sir
@JimHowDigsDirt
5 жыл бұрын
Great tip! Nothing worse than having to do the same job twice!
@n9878f
9 жыл бұрын
Great tip... Thank you for doing this video
@terryiliffe1482
4 жыл бұрын
thanks for the tip, i am going to buy a T190 with a faulty drive motor from the auctions next week. Are they are big job/hard job to replace ? very expensive to get them rebuild ?
@10strad
4 жыл бұрын
I got the final drives from a rebuild shop in never had any further problems. Not too bad to change a lot of time cleaning out prior..make sure you also inspect the lines well as they do rot out
@terryiliffe1482
4 жыл бұрын
@@10strad thanks for the reply...
@lancesutton8473
3 жыл бұрын
Is it possible to change the hub oil without removing the tracks?
@10strad
3 жыл бұрын
Absolutely there are screws on the final drive should be three put one up one down and one sideways
@premyslnovy1357
4 жыл бұрын
what oil to use (specification pleas) and how much in final drive? sorry, my english very bad ;-)
@10strad
4 жыл бұрын
Sorry just saw this.. 80/90
@premyslnovy1357
4 жыл бұрын
10strad ok. And hod much? 0,5 liter?
@10strad
4 жыл бұрын
@@premyslnovy1357 the primary should be half full. Put the two cap screws horizontal and fill one side until it runs out the other should be around a court may be a little more
Пікірлер: 13