Been looking for a nice clear video on this thank you ❤
@DrLumpy
5 жыл бұрын
Once you've done the trig for hole #2, you now know the values. Don't repeat the math, just change the sign of the value. Eg if #2 is XXX,YYY, then #3 is -XXX,YYY. #5 is -XXX,-YYY etc. Thanks - Lumpy
@connorwyandt97
5 жыл бұрын
You're correct. I did forget to mention why I stopped at hole #2 with this bolt pattern.
@donovanfourie5202
Жыл бұрын
I am not sure it will work for 7 holes ?
@jay3035
6 жыл бұрын
Hands down the best video yet for bolts coordinates solver. Could not be better explained and understood. Look forward for more videos from you on the subject. Thank You.
@connorwyandt97
6 жыл бұрын
Suren lolldharowa, I'm glad that you found the video helpful. Now that I'm done with school I plan to make more videos, and redoing this one with a better camera setup.
@marcosduran1443
4 жыл бұрын
thank you so much!😃
@lunditv
2 жыл бұрын
I love this one
@1bengrubb
3 жыл бұрын
its ancient secret.. sohcahtoa....1. sine(degrees whichever corner) =opposite side/hypotenuse-- 2. cosine()=adjacent side/hyp 3. tangent() = opp side/adj side
@dmccune7
6 жыл бұрын
Thank you so much. This helped a lot!
@connorwyandt97
6 жыл бұрын
Devon McCune I'm glad it helped.
@brianbures4478
4 жыл бұрын
Go to the machinist handbook it he’s all the info you need!!!!
@rogerdeane3608
3 жыл бұрын
Never seen any body use calculator to find 6 out of 360.
@joeschmoedontjaknow486
4 жыл бұрын
There you go. Americas future underemployed engineer.
@connorwyandt97
4 жыл бұрын
I actually learned this and decided to show people how to do it for machining. You can use it for a lot of different jobs
@billrichardson4873
4 жыл бұрын
never have seen anyone teaching to get the x- y lines wrong
@connorwyandt97
4 жыл бұрын
What part of the x-y lines is wrong? Did you not get the right x-y values? I'm acctually curious I've used this fine for years now, but I know not everyone learns/thinks the same, what works for me may not work for you.
@billrichardson4873
4 жыл бұрын
@@connorwyandt97 well maybe you miss spoke. You called the line going from 0 out to the right the y axis, and line from x to 60 the y axis
Пікірлер: 20