STL
www.thingiverse.com/thing:240...
Thanks Cmooney91
I went in the trials of mistakes and successes to make a bipartite plaster mold for other future videos
the process was very simple
using a milk carton (recycling) to make the mold
using a part made in the 3d printer STL is above
throwing the glued plaster in the milk carton
as demolding I used kitchen detergent (don't save on this part) to facilitate the mold separations
as it appears in the video I had to make 3 molds the first one I didn't close correctly so the aluminum leaked
on the second attempt the mold was wet
and in the third the mold broke but it was possible to use the casting
#CastingCraft
if you liked the content, click on the like and subscribe to the channel
KZitem subscribe:
/ castingcraft
WARNING
be very careful if you are going to emulate the things in this video,
do it at your own risk,
I am not responsible for your actions,
Always wear protective equipment!
Негізгі бет Ойын-сауық Bottle opener connecting rod cast in aluminum using plaster 3D print
Пікірлер: 14