What adjustments are needed if the nut has been tightened to the top of the cable with no more room to go and the magnet still is not quite flush with the bottom of the plate?
@victoriahawco
Жыл бұрын
We're having the same problem right now. Did you figure it out?
@sbjohnson73
Жыл бұрын
Have had my M8 for 3 years now and have had all sorts of problems with the tensioner. Followed the instructions to no avail. Some times it has NO tension, other times too much. Display jumps back and forth even though resistance hasn’t been adjusted. What was one a good machine is now a huge piece of junk. Will never buy another one.
Пікірлер: 3