D@mn awesome technical information… probably the most in depth & informative video I’ve watched. Hugh 2-thumbs up
@oldfatcrabby
4 жыл бұрын
Please do another one of these videos that cover layouts for bowlers with lower ball speed, as an example 13.5-14.5mph. My experience is that when throwing a ball in this speed range the ball motion is substantially different than one might see if you throw the ball at 17.5 mph. Thanks and keep up the good work.
@denmanfite3156
2 жыл бұрын
By my experience: lowering ball speed and not taking your hand out (revs/rotation, which for some folks may be difficult to do) means it will be less likely to push THROUGH the flare point, it gives your cover stock more time to work on the lane surface.
@mitchellportee150
2 жыл бұрын
My mind is blown. Thanks for explaining this. Now it make sense...
@machinethesun9243
2 жыл бұрын
I wish there was an app, where you type in your specs, and the length of the oil pattern you are bowling on, and its spits out the specs of a hypothetical arsenal including covers, sim, asym, and layouts.
@fadino1786
4 жыл бұрын
GREAT INFO THERE, THANKS
@matafungsi89
2 ай бұрын
What software did u use? Look awesome
@mitch357
4 жыл бұрын
Very informative video. Thank you
@GorgonOfZola
4 жыл бұрын
Forgive me if I missed it during your presentation but do you have a link to other videos on how to determine my specs? Thanks for sharing this video and may I suggest to please release more like it. Well done.
@jeromed.2505
4 жыл бұрын
Shot 2 300 games last month with that straight layout. My first angle is 90 degrees instead of 120
@nickschneider150
4 жыл бұрын
very informative thank you!
@markcorreale8495
4 жыл бұрын
You need to use slow motion ball rolling models to demonstrate roll, migration, and hook. Thank you for a fine presentation.
@Ctdbowling
4 жыл бұрын
kzitem.info/news/bejne/upV8u6hthKyZe4I
@izzem
4 жыл бұрын
I've been trying to get my dad to understand why he isn't getting the same reaction from his Blck Widow as he does his symmetrical ball. Hopefully this will help
@GOTxEMxCOACH
4 жыл бұрын
cool video - one suggestion to your voice recording though, use a pop filter on the microphone. it will help with some of the harsh moments on the microphone and i had to play with my volume a few times throughout the video.
@allee68
2 жыл бұрын
You mentioned that drilling into through the pin voids the warranty. Is that not why they went to DOT? I know my paragon is DOT tech.
@nicholauscurphey3925
2 жыл бұрын
At the end you show the two handed bowler, but it has the thumb and the center of grip is between the fingers and the thumb. What would this look like with the center of grip between the fingers?
@FredSoDak
6 ай бұрын
Layout 2 at 6:29 shows pin in ring & psa in thumb. I do not know of anyone with a 6" plus span! Wow!!
@kinpin0412
2 жыл бұрын
Is it best to have the same layout for symmetrical and asymmetrical bowling balls?
@johnrocksvold9105
4 жыл бұрын
Awesome video
@igorhabljak3218
4 жыл бұрын
Hi Ron, could you elaborate on the speed part of the bowler specs? What speed is referred to here? Is it off the hand speed or average speed (it is a difference of some 15% to my knowledge and varies with the pattern on the lane)? How much of a difference does the speed change make on the layout itself? Does it need to be a 3-4Mph difference, or even a 1Mph change causes the layout to be different?
@Ctdbowling
4 жыл бұрын
Ball speed should be measured off the hand to be as accurate as possible. That helps to eliminate other variables like the lane and friction.
@audriusleleika929
4 жыл бұрын
could you please explain about traction ball layouts: you start 10 x 3 3/8 x 60 (9:24) then you jump to 45 x 3 3/8 x 60 (9:31)
@Ctdbowling
4 жыл бұрын
Yes the 10 x 3 3/8 x 60 is correct. The other is a typo.
@Zardoz125
4 жыл бұрын
Thanks
@julianelam599
10 ай бұрын
Question If I brought a new bowling ball and use a 45X4X35 continuous motion on any asymmetric bowling ball does it make any difference whatever coverstocks there is
@ATLFUNKCARTEL
6 ай бұрын
Coverstock accounts for like 75% of the balls reaction. So yes, it does.
@305bwoy
4 жыл бұрын
any info on bowling with a pinky and ring finger grip? started experimenting but wondering what info is out there?
@Ctdbowling
4 жыл бұрын
Not that I'm aware of
@TheBigfoot1999
2 жыл бұрын
So how/where do you find what layouts are good for your particular game? Example: I'm 24ish degrees of tilt, PAP is 5 3/4 over 1/2 up, 350ish revs and about 17mph off the hand.
@Monk-Amani.
Жыл бұрын
Your Ball driller?
@postalone2
3 жыл бұрын
How do I find out my axis point before I go to the Pro Shop to get a ball drilled?
@Ctdbowling
3 жыл бұрын
kzitem.info/news/bejne/0Z-Gx3mIjYh1jaA
@jameskliewer5809
3 жыл бұрын
I've been trying to find a new undrilled #15 Track 503C, but there don't seem to be any available. Is the Roto Grip Nuclear Cell my best option in a currently manufactured ball?
@Ctdbowling
3 жыл бұрын
I would look at the track Tempo for a current replacement
@jameskliewer5809
3 жыл бұрын
@@Ctdbowling Thanks a bunch!
@joepalizopalizo648
3 жыл бұрын
What ideal for straight ball layout 90 or 120
@xXkyleownedXx
4 жыл бұрын
what program is this??
@T4eTurtleC1ub
4 жыл бұрын
Powerhouse Blueprint
@silentthrower6785
4 жыл бұрын
How do you know what's good for you at the layout
@Ctdbowling
4 жыл бұрын
You first get your specs and then find a good pro shop to help you layout your ball.
@meddis74
Жыл бұрын
Can you please break this down to a level of a true beginner and or for someone like me, who doesn't understand what you're saying??????
@rickdavis8410
2 жыл бұрын
It’s no wonder why we can’t get new people interested in bowling.
@dougspry3101
4 жыл бұрын
Val angles lower than 40 dont work for me. Never have, never will.
@bowlingfanatic20
4 жыл бұрын
average bowlers do not throw 17 mph
@Ctdbowling
4 жыл бұрын
Average bowlers do actually. We have plenty of data to back that up. Including from USBC.
@evanouk3297
3 жыл бұрын
The psychedelic soybean classically post because moon postsynaptically approve against a tan july. dirty, flimsy server
Пікірлер: 47