ATE Brake Caliper Rebuild and Assembly after Repair and Painting Car: From Focus 3 ST / Kuga 2 - 320mm brake disk #brakecaliper #rebuild #assembly #fordfocus #restoration #carrestoration
Outstanding quality-- lighting, focus, and orderly procedure. (And we didn't have to listen to sub-standard music!)
@hamitinan6422
11 ай бұрын
normal gres kaucuğu bozar. silikon gres gerekli
@fred23hope68
Жыл бұрын
should have greased the slide pins.
@FreeKanal
10 ай бұрын
No you don't lubricate those type of slide pins.
@Rockyboy120
10 ай бұрын
Why not ?
@FreeKanal
10 ай бұрын
@@Rockyboy120 The elasticity of rubber pulls these pins back and if you lubricate them, the lower part of the caliper will not go back as much as the upper part(because of weight) and the pads will wear slightly at an angle. These types of calipers should not be lubricated. These pins run dry, another story is with pins that works inside caliper these one we lubricate but with proper grease that doesn`t swell rubber. If we lubricate them with the wrong grease they may even seize.
@Rockyboy120
10 ай бұрын
That’s interesting, I was not aware of that, thanks.
@dnacannotchange
9 ай бұрын
Does rus😂😂t behind the square seal cause a leak because the rubber seal looks fine to me I'm looking at it right now
@frundlemud
11 ай бұрын
Piston goes in with a little brake fluid.
@Northwesternforcefield28
11 ай бұрын
Or red tacky, since it’s a grease compatible with the dot four and 3
@mullaway5746
Жыл бұрын
Need to grease the pins and the ends of the pads
@6wood
Жыл бұрын
ATE company says they can't be lubricated. But why not.
@FreeKanal
10 ай бұрын
You don't lubricate them.
@emilianogabriel9613
Жыл бұрын
what kind of grease are you using because it will mix to brake fluid and fluid become contaminated its ok use that kind of grease
@ftsftw418
10 ай бұрын
No never in my life have I seen this done
@armchairtin-kicker503
6 ай бұрын
There is nothing absolute about using brake fluid. As I understand, red rubber grease may also be used.
@peterzinia3767
11 ай бұрын
A little heavy on the lube. You only need the hit the inner seal & a little in the dust boot.
@NABILSAQRAN
9 ай бұрын
You need two weeks to finish one piston
@ivan.bucher
3 ай бұрын
treating this like a model airplane build...
@CryptoPaperRoute
10 ай бұрын
omg you didnt grease the only thing that you should have THE SLIDE PINS!!!!
@ftsftw418
10 ай бұрын
You Sure you know what your doing never heard of this
Пікірлер: 22