The brake fluid and clutch fluid services for BMW E90 M3 with 6-speed manual transmission, done with basic hand tools (no power tools used!) The clutch hydraulics is connected to the brake hydraulic system so its fluid can be replaced at the same service. Always top up the brake fluid reservoir and avoid air getting into the hydraulic lines. Pump the pedals (brake or clutch) until clear and bubble-free fluid comes out.
It is also required to remove air bubbles inside the brake hydraulic line. ISTA is used to activate the DSC module for this part. After actuation of the DSC module, flush the brake line again by the same method mentioned above.
**Required fluid**
Ate DOT4 brake fluid X 2 liter
(Use 1 liter for flushing the hydraulic lines and 1 liter for flushing out the air bubbles. Use all of the fluid, no need to save them for the next time because the brake fluid degrades by absorbing moisture in the air.)
**Required personnels**
Good people X2
**Required tools**
Jack stands to lift the car
Breaker bar or impact wrench (removing the wheels)
8, 10, 11, 17 mm hex sockets
9,11 mm spanners (brake bleeder valves)
Torque wrench (120 Nm, for wheel bolts)
**Sections**
0:00 Opening
0:19 Intro
1:27 Removing wheels
3:09 Drawing brake reservoir
5:37 Replacing brake fluid
8:12 Replacing clutch fluid
12:53 Removing air
14:58 CBS Reset (with column switch)
15:40 CBS Reset (with ISTA)
16:42 Restoring everything
19:15 Summary
Music: Runnin On Empty by Desert Dive
Content ID: NBH4FC0FJ8KQWLBS
Негізгі бет Автокөліктер мен көлік құралдары Brake + Clutch Fluid Change DIY + CBS Reset for BMW E90 M3 (6MT)
Пікірлер: 25