Thanks for the video but if you are making “how to” tutorials don’t put stupid music in the video that makes it hard to hear what you are saying.
@hponce
8 ай бұрын
I never understood what was in the red bottle that I used after taking it out of the water.
@deanslittleworld2745
8 ай бұрын
That's a lighter fluid you can buy that in any hardware store.
@patrick-beta
7 ай бұрын
Yes, that is correct! Its a lighter fluid.
@davegee124
5 ай бұрын
why did you put oil on the commutator?
@shelly6482
Жыл бұрын
Will it be faster?
@jakelang4387
2 жыл бұрын
I still do this ,,I've had some brush motors almost be as strong as brushless in the end but brushless is way better
@n00b247
7 ай бұрын
Remember to do this only with brushed! Brushless doesn't like that kind of "oil inside" treatment.
@wildcat650power
3 жыл бұрын
Good video, thank you
@toddshobbyzone659
4 жыл бұрын
2 minutes in distilled water and a few drops of simple green
@NeoJ4K3
3 жыл бұрын
why the simpl green?
@toddshobbyzone659
3 жыл бұрын
@@NeoJ4K3 I normally use the simple green on a motor after I ran to help clean-- just habit on breakin
@NeoJ4K3
3 жыл бұрын
@@toddshobbyzone659 hmm, my kit just came in today, maybe illtakr your advice on the simple green
@toddshobbyzone659
3 жыл бұрын
Make sure you oil up bushings afterwards
@patjefpv6825
4 жыл бұрын
20 min way to long Brushes completely worn away on new motor
@patrick-beta
4 жыл бұрын
Throttle input is not that high just enough to spin the motor and immersed in water is less friction it act as lubricant. Maybe if run dry and 100% throttle input it will completely worn away the. brushes.
@patjefpv6825
4 жыл бұрын
My throttle input was just done with the throttle trim and motor was immersed in water Now i do the same for 2 1/2 minutes and the brusches are perfect now
@jalee6587
2 жыл бұрын
What the hell are you recording on a 5 dollar camera. People in the Philippines don't have decent cameras or what. Looks like your phone is from 2005
Пікірлер: 19