Well done! Briggs and Stratton are incredibly reliable engines. Perfect application. Can't say ive ever had a lawn mower engine failure that wasn't fuel exhaustion related.
@raydreamer7566
4 жыл бұрын
Really well done installation and I like your custom mods. The V-twin looks good from the cockpit and almost looks like it should have the RED cross hairs with the circle on it.
@1casalfeliz
Жыл бұрын
Beautiful little plane! Using industrial engine is a great idea, they are designed to run for hours at peak rpm (which is usually low) and are much cheaper than a Rotax" Thanks for sharing
@deborahchesser7375
Жыл бұрын
They are definitely a good value, I use them on everything from motorcycles to hauling wagons ✌️🇺🇸
@carpenter123154
Жыл бұрын
Thanks for sharing this entertaining video! Beautiful plane and mechanical execution.
@deborahchesser7375
Жыл бұрын
Absolutely the coolest thing I’ve ever seen ! I want one ! ✌️🇺🇸
@stolaircraftsuyanto9728
2 жыл бұрын
amazing my friend
@MrBruintjebeer
4 жыл бұрын
It is a Masterpiece! Great airplane.
@lucabaldi2227
4 жыл бұрын
Oui merci.
@jim5148
6 ай бұрын
Very neat. Are you still using this engine 4 years later?
@GrantOakes
2 жыл бұрын
Remove the engine governor, put in a set of performance pistons, cam, billet rods and lightened billet flywheel and you'll get a solid, reliable 35-40hp. Then add an Ace Aviation PRSU to turn a larger prop slower and your plane will run a whole lot faster!
@lucabaldi2227
2 жыл бұрын
Thanks, maybe on the next plane ...Ciao, Luca
@samj1185
3 жыл бұрын
Great work and great plane. Too bad it's way too fast for US UL category. It's certainly light enough.
@lucabaldi2227
3 жыл бұрын
Thank you, approach at 45/50 knots, landing at 40 knots. Ciao
@denniswilliams8747
4 жыл бұрын
I would like an update on the motor, performance and hours on the engine ETC THanks
@mc30it69
4 жыл бұрын
The avionization work of the B & S Vanguard is described in detail in the M.Colomban manual. If you want to do this job I suggest you ask Colomban if you send one. In principle, the work to be done is as follows: remove the casing and the guards eliminate the flywheel eliminate the power regulation system move the carburetor under the engine install the long suction manifolds build the carburetor's air intake replace the carburetor float bowl install the HDC ignition, now I moved it or (see info Infos 28, Infos 26 2018 by mr Colomban) install a flange for the oil filter, now I'm building a new one make the tube for the heating oil of the intake manifolds build exhaust manifolds build the muffler build the exhaust pipe Lot of work! A lot of money, about 5000 euros, including the engine! Keep in mind that the B & S is made with a bad alloy and has very cheap mechanical solutions. In the air I'm always worried about the engine. Unfortunately there are no alternatives for Luciole. Actually my second engine has 300 hours. It is an 25hp engine.
@myotherusername9224
3 жыл бұрын
"Unfortunately there are no alternatives for Luciole" Half VW ?
@lucabaldi2227
Жыл бұрын
No, it's already too cold. Ciao
@leneanderthalien
Жыл бұрын
nice except, the oil cooler who is in extremly unnefficient position: need a radiator with the same surface area, but low in height and wider, positioned in the direction of the air flow would be much more efficient and would allow a much prettier and more efficient fairing...
@performancemudmotors
Жыл бұрын
You need have third coast performance design a turbo system for this aircraft
@eslanek785
2 жыл бұрын
What engine model is it?
@germanfarizano9104
4 жыл бұрын
where I buy the plans
@drevil7878
3 жыл бұрын
От музыки блевать хочется. А самолёт крутой.
@АндрейКохановский-ы1я
4 жыл бұрын
what is the thrust in kilograms on this propeller?
@lucabaldi2227
4 жыл бұрын
I'm sorry, I don't know
@DrStoooopid
2 жыл бұрын
Is that direct drive? Or reduction drive?
@lucabaldi2227
2 жыл бұрын
Direct. Ciao
@DrStoooopid
2 жыл бұрын
@@lucabaldi2227 Gratze, Amiga.
@MrPagnu
3 жыл бұрын
Quanti cavalli ha questo motore?
@mc30it69
3 жыл бұрын
25 hp
@mizanahmed9501
4 жыл бұрын
This engine price...
@МихаилБуров-ц1у
4 жыл бұрын
3200RPM это взлётный режим?
@mc30it69
4 жыл бұрын
Нет круиза. Если вы напишете мне по электронной почте, я пришлю вам все данные. No on cruise. If you write to me via email I will send you all the data.
@МихаилБуров-ц1у
4 жыл бұрын
@@mc30it69 Ok
@stolaircraftsuyanto9728
2 жыл бұрын
@@mc30it69 Какой максимальный взлетный вес в килограммах?
@mattewgrigg5135
4 жыл бұрын
Man I be scared if the motor blow mine did on a go kart
@2Phast4Rocket
3 жыл бұрын
The EFIS costs more than the engine.
@lucabaldi2227
Жыл бұрын
No, it's already too cold. Ciao
@oldschoolfoil2365
2 жыл бұрын
after running lawn mowers never thought one would exist. There you go. need these parts for lawn keeping. BTW nice landing like the mowers low and slow. :)
@canoe365
3 жыл бұрын
Are the copper tubes for carburetor ice prevention? If so, could the warm air from the oil cooler do the same job? Just curious. Beautiful work! When I grow up I want to be like you! P. S. I'm 63 years old.
@lucabaldi2227
3 жыл бұрын
Thank you. No, the copper tubes are used to heat the intake manifolds. The carburetor is heated using the heat from the muffler, a classic. I'm 61. Ciao.
@DirkHav
4 жыл бұрын
Fantastic ultralight ! I like SD1, but I like Luciole more and more. It is a wonder that your engine is not undercooled, it's always open in the wind. It's very good to install a thermostat for the oil.
@mc30it69
4 жыл бұрын
Thank yuo.Ciao
@АндрейКохановский-ы1я
4 жыл бұрын
hello, what is the diameter of the propeller? what is the engine power?
Hello my friend, all right in the installation I saw that you have placed a radiator for oil cooling the need. the need to do this for this engine
@BobSmith-te6rf
3 жыл бұрын
I watched this video multiple times - it's absolutely brilliant. Incredible work on the oil system! Thank you for posting this video. I hope in the future you can create more uploads. Subscribed!
@mc30it69
3 жыл бұрын
Thanks. It's hard to make decent videos. As soon as I can I will do one on how the Luciole flies. Ciao
@BobSmith-te6rf
3 жыл бұрын
@@mc30it69 Your videos are actually made very well. Good music, clear text subtitles, and smooth camera work. Grazie mille! (I'm just wishing I could purchase that mysterious red ignition box for my V-Twin....)
@@mc30it69 Thank you for the link, but I understand that's the oil thermostat in this video. The "red box" I was referring to is the electronic control unit (that you relocated behind the firewall) connected to the coils, mentioned in your video "Luciole 114 ignition". I think you once called it the "HDC ignition", but I can't locate more information. Possibly the ignition module comes from M Colomban, and he may not sell engine parts to people in the USA :( But thank you again for posting the thermostat link, and for responding to my comments, that was very nice of you. Blue skies!
@lucabaldi2227
3 жыл бұрын
@@BobSmith-te6rf Please write to my email. You can find it in the video.Ciao
@gastonlebob
5 жыл бұрын
hello, I saw that you have replaced your oil filter mount. I'm a mc30 builder, I'm interested by the old oil filter mount. Are you interested to sell it to me ? thank you Anthony
@lucabaldi2227
5 жыл бұрын
It is possible, but the new one passes more oil and therefore the engine is cooled better. At the bottom of the video is my email. Ciao
@calanmacleod3948
Жыл бұрын
Informative video, great aircraft.
@АлексейДобряков-к4и
2 жыл бұрын
Добрый день!Какую тягу развивает этот мотор с винтом?
@lucabaldi2227
2 жыл бұрын
Я не знаю. Полет на скорости 150/160 км/ч при 3250 об/мин с расходом около 3,8 л/ч. В конце моих видео вы найдете мою электронную почту, если вам нужна дополнительная информация. Ciao
@АлексейДобряков-к4и
2 жыл бұрын
@@lucabaldi2227 Спасибо!
@lucabaldi2227
2 жыл бұрын
@@АлексейДобряков-к4и Пожалуйста, Ciao
@jamesglass3278
4 жыл бұрын
I was wondering what kind and size prop is used and what it's pitch is.
@mc30it69
4 жыл бұрын
Diametro elica 116 cm, passo 80. Harplast Helice, France. Ciao
@markross6818
Жыл бұрын
I think it looks better than a half VW and that cooler setup is nice 👍
@АндрейКохановский-ы1я
3 жыл бұрын
tell me from what the composite spring, did you make or buy it yourself? Thank!
@mc30it69
3 жыл бұрын
I can't understand what you mean by "composite spring". Ciao
@myotherusername9224
3 жыл бұрын
@@mc30it69 I think he means main landing gear, the support between the fuselage and the wheels.
@lucabaldi2227
3 жыл бұрын
@@myotherusername9224 Thank you. The main landing gear is sold by Heol Composite fr. Ciao
@davecox1697
Жыл бұрын
What maximum static rpm are you getting with that setup?
@lucabaldi2227
Жыл бұрын
3050/3100, it also depends on the pitch of the propeller. Ciao
@davecox1697
Жыл бұрын
@@lucabaldi2227 thank you😊
@lucabaldi2227
Жыл бұрын
@@davecox1697 prego
@shivdasbairagi6520
4 жыл бұрын
Haw many kmph of speed
@lucabaldi2227
4 жыл бұрын
Economic cruising speed: 150 km / h. Consumption: about 3.8 l / h.
@shivdasbairagi6520
4 жыл бұрын
Propeller RPM
@mc30it69
4 жыл бұрын
@@shivdasbairagi6520 3150
@shivdasbairagi6520
4 жыл бұрын
Propeller size
@mc30it69
4 жыл бұрын
@@shivdasbairagi6520 Diametro elica116 cm, passo 80. Velocità di crocera 150km/h a 3150 giri. Ciao
Пікірлер: 80