Baja action? LOL I see that sleeved up dana 30 held up. Thats actually very good to see and it reinforces my notion that sleeving will absolutely give good strength to MY dana 30 in my jk after I sleeve it up. Very glad to hear that the housing held up. I can see where you made the holes and welded it in on the housing.
@chadmunn7656
5 жыл бұрын
The Dana 30 is stronger than people think. Huge respect to you for taking responsibility for driving like a fool and admitting your mistake a real man sir. Great video and wishing you the best!!
@1badhoekaren903
5 жыл бұрын
Amen to that. Seen lot of people run 40s with stock axles, wheel it hard and never had any issues. I belive it all comes down to how you drive it.
@WeKnowTheTruth2012
5 жыл бұрын
Its not to shabby but the 44 is awesome for the price
@usernameTheInnerTube
5 жыл бұрын
That's what's commonly referred to as a dumb ass attack. Don't feel too bad, as I've had my fair share of them also.
@evanperry3699
5 жыл бұрын
In one of the worst situations you could put your Dana 30 into and only broke the ring and pinion. Built up or not, that’s definitely the Dana 30 proving itself.
@Slobberdog66
5 жыл бұрын
Hey Rusty that sucks , I hope you’ll show us the whole repair. Your install and repair videos are very helpful.
@danhambrick6331
5 жыл бұрын
Damn Rusty!You did a number on Black Betty..Dont you know that R is for Reverse Not Race...lol...
@beaver_creek_outdoors2010
4 жыл бұрын
Been there, done that ! LOL
@jake-mv5oi
5 жыл бұрын
If you're gonna break it, break it good! Guess that shows how much stronger the gears are on the drive side than the coast side. That's pretty impressive that everything else held up too. Even more so that you drove it back home.
@TheAmericanUhate
5 жыл бұрын
Seen this on your FB group a while back, still looking forward to the repair videos of the axle and transmission both
@flatwoodsjeepclub1938
5 жыл бұрын
Well as the saying goes "shit happens".. Hope you get it back on the trails soon.
@Hadouken5150
2 жыл бұрын
What did you expect, those 40s belong on some built Dana 60s.
@Rusty411
2 жыл бұрын
Yeah been going just fine for years now and three other jeeps in my group same set up the carrier bent once in three years
@Hadouken5150
2 жыл бұрын
@@Rusty411 well good on you man. If it works it works, sounds like you have it figured it.
@Hadouken5150
2 жыл бұрын
Also I was a dumbass and didn’t watch the entire video. That mistake you made would’ve done the same thing to a D60 I’m sure.
@bearfarmer
5 жыл бұрын
Tuff luck, but the hubs held up!
@BornRandy62
5 жыл бұрын
at the end of the day was the beer cold? I worked on a Dana 60 where the guy had switched ring and pinion and didnt tighten all of the bolts. You can count how many times that bolt got slung out into the cover before it got caught someplace it couldnt spit out. I pulled a literal handful of metal filings out . They did the repair without cleaning the case. I didnt ask how they thought leaving loose metal pieces inside a gear case was a good idea
@natekelly4667
5 жыл бұрын
Damn Gina!!!! Those gears are wall hangers for sure. Lol. Oh well at least you might know someone who can fix it.
@TheAmericanUhate
5 жыл бұрын
He's an ASE certified master mechanic. Unless you meant he knows himself lol.
@user-qz3ei9ps6l
4 жыл бұрын
Виновата блокировка 100%. How long ran dana 30 with locker and 37s? Gear ratio?
@Rusty411
4 жыл бұрын
About 5 years now 4.56
@user-qz3ei9ps6l
4 жыл бұрын
@@Rusty411 5years with hubs?
@Rusty411
4 жыл бұрын
About 2 years on 36s and then 3 years with the hubs and 39.5
@user-qz3ei9ps6l
4 жыл бұрын
@@Rusty411 wow. I'm in Russia and want to build xj on 37's with dana 30/35 (because 44/50/60 are not available) How will it better to make lift and which hubs can i set to dana 30?
@eddieriggins845
3 жыл бұрын
How is a pinion gear set up on a Dana 30
@geostanley409
5 жыл бұрын
Holy shit! Does that mean you’re gonna make Jeep videos again? Been a while since we got some good informational content from your channel! Hope all is well. Have a Merry Christmas and I hope to see a new video from you before the new year!
@TheTexasPsyclone
5 жыл бұрын
Did the same thing to my 97 f-150 - was in 4 low and went down a steep hill into the San jac river and pulled it down into 1st - too steep and too fast and the front diff grenaded. Spider gears exploded. Lol Tough break...
@wranglernash5799
5 жыл бұрын
I really like cherokee
@badlt.5189
5 жыл бұрын
Holy Hand Grenade Batman! O.O My wife was out messing around in her JKUR and bent the rear axle, so I guess I'm upgrading hers to 1 tons...lol So my XJ is now on hold again. :(
@TDHobbies
5 жыл бұрын
Well, I guess those hubs are kinda strong after all
@markandes4143
5 жыл бұрын
DOH!
@steveballard1463
5 жыл бұрын
Hey,You Broke some shit, Opss
@southgajeeepers2416
5 жыл бұрын
Damn man. Shit happens. Next time you have a big ride. Or go to one let me know. I need to get the Jeep back in riding mode. I been hunting out of it since September. I wanna ride with Clint again. I can only imagine what that jeep will do now with boggers and a stroker
@TheEcono61
5 жыл бұрын
Well crap! Oh well, that's kinda to be expected when you go to reverse at speed.
@TheEcono61
5 жыл бұрын
Sure want to check the axle splices real good, may have twisted the shafts.
@kenneymartin1895
5 жыл бұрын
TheEcono61 he knows what he’s doing buddy
@sandyphillips6913
5 жыл бұрын
Did you buy a hub kit or what did you use.
@Rusty411
5 жыл бұрын
It has the Yukon hub conversion.
@michaeldurling793
5 жыл бұрын
Now I know you don't normally fool around like that OOPS ! How come that shifter doesn't have some sort of tab you could flip to block accidentally hitting reverse? I know you could engineer one if ya wanted to.
@Rusty411
5 жыл бұрын
Yeah def need to do that I usually would never shift it at all less I backing up one of those brain fart moments lol
@Gold_Falcon_6
5 жыл бұрын
That sucks!!
@rhondaminor7552
5 жыл бұрын
All because Jennifer wasn't there to "reel you in" huh? Lol Mistakes happen, especially when you are having fun, cutting the fool. 😜🤣😹😂
@maxm8986
5 жыл бұрын
That's not good but is good to see a video from you. Hope you can post the repair videos
@fishhead6349
5 жыл бұрын
Way to go Rusty! Heehee
@drubradley8821
5 жыл бұрын
Sorry to hear that Boss, .... You'll get it dialed in, and rocking and rolling in no time. I don't know what ratio you have, but I have a brand new in box, ring and pinion and master bearing kit with crush sleeve, etc., that you can have, it is the highway gear set... (((3.73:1reverse cut for H.Pinion pigs))). You are welcomed to it, I can rummage through my sh*thole, called a shop, and dig'em out, and can have them in the mail on Monday, and if need be, next day air them for you. If my memory serves me right, they are "Auburn Gear" brand, which is manufactured approx 50 miles away from where I live in Auburn IN. ..... I have a set of used DANA Corp, gears, which is the 4.11:1 ratio and a set of 4.10:1 ratio... for the life of me, can't remember which those are cut for, either high pinion or low pinion??? But those two sets are used, very litely, from a DANA 30 that was supposed to be a daily driver, and the after less then 400 miles, sold the XJ's and scrapped the doner XJ... Beings they were both XJ's, I am gonna lean towards those two sets are reverse cut, for the high pinion diff's.. Lol, in fact, I remember taking them out, and still had Prussian yellow on the teeth, after the 400 miles, lol. I had the one set, but was one tooth to many for the full-time 4wd and had to buy the 4.10:1 set, ... Blah.. Blah... Anyway, let me know, and I can have a set sent to an address of your choice, as per security and privacy goes... I also do have a few sets of low pinion ring and pinion sets... those are much used, street use, no off roaring on them, but very likely over 50,000 miles of 250,000 miles, I don't know... Now I am asking myself, "Why in the h*ll, am I hanging on to gears that have unknown mileage on them, ????lol... Pack rat, (( 🐀)).... I guess.. Dru
@Rusty411
5 жыл бұрын
Im.gonna pickup a set of Yukon 456 to go back in it bud be ready to go soon
@drubradley8821
5 жыл бұрын
@@Rusty411 ah, that ring is pretty thick, I shoulda seen that.. Yukon is some tough stuff.
@robertklein778
5 жыл бұрын
impressive
@sandersbaldwin3755
5 жыл бұрын
Yeah you went and did it actually don't take too kindly to that type of action but you get her fixed and get it back on the road get it back in the woods keep up the awesome videos brother have a Merry Christmas
@stephenhickman9502
5 жыл бұрын
Fixing it is half the fun.
@lol123321123321
5 жыл бұрын
I think we all knew it was just a matter of time before the Dana 30 blew. It's awesome that you pushed it to the limit and ran 40s. Yours being sleeved and gusseted is basically as strong as a Dana 44 besides the ring and pinion now. 7 1/8" in ring gear is puny for 40s! Maybe experiment with those freeze treated ring and pinions
@TheAmericanUhate
5 жыл бұрын
It didn't break due to lack of strength or the 40's, it broke because it went from 45+ mph straight into reverse. It would have broke something no matter what. Sucks it broke his transmission as well. I'd much rather break the front end than the transmission.
@TheMotoManiac
5 жыл бұрын
Is titan engine the place he got the motor from? Or maybe jasper?
@Rusty411
5 жыл бұрын
It was titan
@TheMotoManiac
5 жыл бұрын
@@Rusty411 I bought a rebuild kit for my jeep there. Good dudes and not far from me
@TM-lw8wn
5 жыл бұрын
oops
@scottchisholm2032
5 жыл бұрын
How much to rebuild my 44re for my zj
@caseyespeseth4306
5 жыл бұрын
Damn
@AMSTUNTZ
5 жыл бұрын
might have something to do with 40s on a dana 30...
@TheAmericanUhate
5 жыл бұрын
More than likely something to do with going into reverse at speed.
@MrWoodworkr
5 жыл бұрын
Did you not even watch the video??
@getoutofthetimetrap5435
5 жыл бұрын
Bummer
@WeKnowTheTruth2012
5 жыл бұрын
Reverse lol
@adamflax4225
4 жыл бұрын
Chinese.
@traemiller9561
5 жыл бұрын
I told you months ago that the 30 wont hold up !!!!!
@TheAmericanUhate
5 жыл бұрын
It didn't break because it's a d30, it broke because it was slammed into reverse at speed. Hell anything would have broke. Sucks it broke his transmission in the process.
Пікірлер: 68