Brilliant job & to the point. Thanks for sharing! Now I have more confidence to repair the front lip spoiler which got minor resin damage going over a ramp.
@Carbodon69
2 жыл бұрын
Thanks i hope this video help you next time in your project
@dover1966
11 ай бұрын
What sanding paper did u use and how long after did u do the buffing
@davidalegreiserte8979
Жыл бұрын
Como puedo reparar un faldón de fibra de carbono agrietado y que pasos he de seguir gracias.
@cartoonking1063
Жыл бұрын
Looks great, you treat the area with tape around, why then sand a wider area and then why use the machine and what liquid is on it?
@pancadlimapanca7016
2 жыл бұрын
Awesome
@brunostiglitz7535
5 ай бұрын
Which grit sandpaper did you use? Which one is best to start with and end with ?
@Carbodon69
5 ай бұрын
You can used 120 to 180 sandpaper on the side you can used 1200 sand paper after you apply the resin leave dried completely for few days and then you can sanding again with 1500 to 3000 sanding paper and water then polishe with 3m cream
@NycForgiato
Жыл бұрын
where are you located?
@ryannichols8315
3 ай бұрын
Man, a rattle can of reducer, and probably wouldn't need the buffer at all. Reducer or a spot blender will melt clear into water like. And you spray it on a couple times right after sanding and wiping it off to soften the existing clear. So your new clear bonds and becomes 1 with it. With the buffer its very similar, you're basically heating up the clear with the buffer, and sanding micro layers.
@xXmoemoneyXx
Жыл бұрын
What was the resin you used?
@Carbodon69
5 ай бұрын
Max 1618 resin
@carlbru2187
2 жыл бұрын
What did you use to repair it? I have the exact same damage to my front lip. (Sandpaper grit? Clear coat? Polish? Etc). Thanks!!!
@Carbodon69
2 жыл бұрын
for this little damage try to sanding with some 180 sand paper with out damage the carbon fabric only sanding the broken resin and then around the damage trying to sanding with some 600 applying some hands of resin after you covered the damage and then you can sanding with 1000 and 1500 sand paper and polished after dried the resin or apply clear coat paint
@carlbru2187
2 жыл бұрын
@@Carbodon69 Thanks!!
@jonnymac8925
2 жыл бұрын
Do you clear coat over the resin?
@BBBoy0608
2 жыл бұрын
@@Carbodon69 Did u just sand the broken part or cut it first, it looks like u have cut the broken part out in the video
@Carbodon69
2 жыл бұрын
@@BBBoy0608 just lift and sanding the broken resin before touching the cabon fabric and i apply more resin on top
Пікірлер: 20