I'm excited to follow this series! Can't wait to see it all come together.
@RCModders
6 жыл бұрын
Same here!
@brekig1136
3 жыл бұрын
I laughed so hard when the Land Rover did not get on the autotransporter 😂😂
@RCModders
2 жыл бұрын
😂😂
@witneydiggersrc3251
4 жыл бұрын
Brilliant, really easy to follow, thanks.👍
@RCModders
4 жыл бұрын
Cheers! 😀👍
@TheDaddy187
6 жыл бұрын
i was thinking right at the start how the side storage would be a perfect battery tray... luckily lipo batteries come in practically every size and shape... as for steering, it shouldnt be too difficult to fabricate... either pinch the front end from a donor or be creative with some plastic/metal brackets... meccano sets work quite well for bits to make steering... not advised for fast or heavy but it should be perfect for this application...
@RCModders
6 жыл бұрын
Thanks. Good thoughts. One of the big challenges will be to keep the cost and complexity down, while creating something with good functionality. I am resisting the temptation of just raiding one of my hobby grade models.
@TheDaddy187
6 жыл бұрын
@@RCModders you have any old pull rods laying about? maybe they could make a decent mounting point for a knuckle... as for the knuckles themselves, maybe using the original axle cut short with the end threaded and fabricating a knuckle with some hdpe (chopping board or melt down some plastic bottle caps) hdpe is decently strong and has some give in an impact... if you could make 2 cubes from it and drill a hole through the same diameter as the original axle then shape it to accept some wire from the servo then a nut on the end where you threaded it then the rest should be easy to get working... another suggestion is to look in charity shops for some old rc cars you can scavenge parts from... most can be had for next to nothing
@RCModders
6 жыл бұрын
Some great suggestions. I think I'll start by trying the knuckles from the Jeep which came free on the back of the Sprinter - they look promising - & post a video of this if it works out.
Пікірлер: 12