Welcome to Electromin, the home of simple electronic projects. 🤗
In this channel, you can build, simulate, and analyze the most common electronic projects on a breadboard, Arduino, and oscilloscope. 👷♂️
You can learn to build more than 60 projects on your own! 🫣
-------------------------------
In this video i made a LED flasher circuit using a 555 timer IC on breadboard 😍
The 555 timer is configured as an astable multivibrator, which basically means it continuously oscillates between two states (high and low) without any external triggering 😬
The output pin of the 555 timer switches between high and low states according to its internal timing. This output signal controls the on-off behavior of the LED 💡
By adjusting the values of the external resistors and capacitors, you can easily change the blinking rate of the LED without needing to redesign the entire circuit 👷♂️
-------------------------------
If you enjoyed the project, please like the video and don't forget to subscribe to my KZitem channel. 🙏
www.youtube.com/@ElectroMin?s...".
-------------------------------
Check out the most viewed videos on my channel: 😍
Clap switch circuit 👏
• How to build Clap Swit...
Darkness sensor 🌚✨
• Darkness Sensor on Bre...
Voltage level indicator 🔆
• Voltage Level Indicato...
Fire Alarm Cicuit 🔥
• How to make Fire Alarm...
Light sensor circuit 🌈
• How to build a light s...
#ledflasher #555timer #breadboardprojects
0:00 Intro
0:40 Components
1:03 Wiring
5:33 Testing
5:45 Explanation
Негізгі бет Ғылым және технология Build a simple LED flasher circuit using 555 timer IC on breadboard
Пікірлер: 2