Build The TAMIYA FIAT 500F
#modelcar #fiat500f #scalemodeling
Tamiya 1/24 Fiat 500F
This time I made Tamiya's Fiat 500F.
This kit is well reproduced in both the engine and chassis.
*Engine
I wired it to the generator, carburetor, and plug cord.
Since it is an air-cooled 2-cylinder engine, there is plenty of room for the plug, so I made a plug cord with 0.4mm electric wire and aluminum pipe.
The right side of the engine compartment is empty.
In the actual car, something like a switch is arranged.
I installed the appropriate parts.
I thought I could install the battery, but in the actual car it is installed in the front luggage compartment.
* Car Body
The campus roof was rebuilt using tissue, nickel silver wire, and copper plates.
I made a belt to fix Hood and the car body with a plastic plate and a copper plate.
I often see it in a real car.
Did the hood open while driving?
* Trunk and rack
I made a trunk with plastic board, tissue, brass wire, and brass pipe.
I made a rack with 0.5mm Nickel-silver wires.
* Inside the car
Place candy boxes, tissue boxes, model boxes, etc.
And I put the T-shirt on the sheet.
Next, I will make a small Japanese car.
Let's meet again!
thank you very much.
Негізгі бет Тәжірибелік нұсқаулар және стиль Build The TAMIYA FIAT 500F
Пікірлер: 21