I was thinking of something similar but putting it on the iMatch on the tractor side. Nice work👍🏻 and great idea, a lot cheaper than the HH.
@houndsmanone4563
4 жыл бұрын
Nice work. I too just built a concrete ballast. Enjoyed a full-watch, Tractor Therapy.
@tractortherapy42
4 жыл бұрын
Nice! Thanks for stopping by!
@kejung1
4 жыл бұрын
Looks clean. Very nice work. May I ask what year your Miller is? Have you any plans to do any videos on the welder and associated goodies?
@tractortherapy42
4 жыл бұрын
I got it in 2016. Since I made video, I sold the Multimatic 200 in this video (which I regret - really liked it), and added a Miller Multimatic 220 AC/DC to add Aluminum capability (which I love). I may do a video on the welder - I'm working on a few new videos. Thanks for stopping by!
@xpoorman70
4 жыл бұрын
pretty sweet...almost like it came that way
@OrangeismyNewGreen
4 жыл бұрын
Hi TT, Ordered the hitch receiver the other day and found a welding shop that will charge me about $80 to do the job, I’m not equipped to do this, can you confirm some dimensions for me, 3/8”x3”x33” and what is the length from the top of the 2” receiver to where the flat bar sits on the middle bar, much appreciated 👍🏻
@tractortherapy42
4 жыл бұрын
The bar is about 36" of 3" 3/8 flatbar - you need a little extra for the bend radius, but there's some wiggle room on that dimension. Shop should be able to trim any excess. To get 8 weights (4 per side) it will have to be about 8.5" from the top of the 2" receiver tube to the top of of 3" flat bar. Make sure 10.75" per side of open space for 4 42# Deere weights. With 8 weights plus receiver and bar its about 350lbs. Good luck!
@OrangeismyNewGreen
4 жыл бұрын
Hi, thanks for the dimensions and for getting back to me so quickly 👍🏻
@OrangeismyNewGreen
4 жыл бұрын
Hi TT, just wanted to let you know I got the receiver back from the welder, I painted it and it’s perfect, thanks again👍🏻
@tractortherapy42
4 жыл бұрын
@@OrangeismyNewGreen That great!
@A-GUY-AND-HIS-TRACTOR
3 жыл бұрын
I'm not a welder but I noticed that you did not weld the backside making vertical welds and only did the horizontal welds on that center piece. Is that because it would be overkill and not needed? I just found you on KZitem and subscribed you have a lot of great content
@tractortherapy42
2 жыл бұрын
Thanks for stopping by! I'm not a welder either! I welded horizontal mainly to keep water out and left side open so it can escape if it gets in there. Probably should have sealed it all up, but the paint will keep it in good shape.
Пікірлер: 15