Thank you for this vid, I'm doing a 04 to 10 swap and this really helped., if I screw it up, I'll send it to you.😊
@JikaInFamous
3 жыл бұрын
i swear you should have hella more views n a following behind you.
@travisthompson3700
3 жыл бұрын
Amazing work as always 👍
@TimHaasw
Жыл бұрын
How do I send you my wiring to get done
@michaelstenli7123
2 ай бұрын
How good are you at wiring 6.4 and 6.0 harness got a 2009 6.4 with a 6.0 engine and wiring harness and it currently do not want to cut the firewall and weld in a 6.0 firewall would rather just put the 6.4 HVAC and wiring
@stedegrissom5788
3 жыл бұрын
How do I get ahold of you to do this? This would make my life so easy in my 02.
@richellis3256
2 ай бұрын
Hello I want to go from a 01 Ford Super Duty to a 08 Ford Super Duty what’s it cost to have you build the harness for me please
@bgoza91
Ай бұрын
Are you still doing this? Haven't seen a reply from you too anyone.
@gavinhenryproductions3389
Жыл бұрын
I need you to wire up my harness for a 04 f350 I’m doing the 08-10 swap
@chrisfreeman8175
Жыл бұрын
What’s the price for dash swap for 2004 f250 going to a 2008 dash
@deputybanks
3 жыл бұрын
Do you have a website we can visit to order stuff
@noonames4887
3 жыл бұрын
So this different then 2000 to 2016?
@JoshuaAbittan-w6q
11 ай бұрын
bro how do I get a hold of you? im trying to talk business with you good sir
@zachmencarelli3706
11 ай бұрын
Any way you could walk me through adding a aftermarket power distribution block under the dash mine started melting and dont have the 350 bucks for a new one my truck is a 02 f250 7.3
@dennisz494
Жыл бұрын
Zach, I purchased a tranny cable from you for an 08 column. I installed the tranny moun t from an 08 tranny on my 04 tranny and it hooked right up. I also redid the wiring in my dash. something gave loose and the harnes got caught in the un iversal join t on the steering shaft. I broke about 10 wires. I soldered them all back. Problem is i have a white wire with violet stripe. Cant find another broken end that it goes to. I can only start my truck by turning key on acc, then jumping the starter under the hoid. The key will not turn it over. I have a wiere schematic and it loks like that wire goes to and IGN source but i cant find it. It goes from the AC module in the center of the dash to the power supply or 10 amp fuse. And i assume splits off to ignition or guage cluster? Do you ha[[en to have an 04 wiring harness that you can see where that wht/vio wire go to? I can't figure it out. I also have a ton of white smoke. I think a fuel injector is open, and i seen in the wire schematic that the same color wire goes to a fuel injector or module for the injector. You wouldn\d't happen to know exactly where this wire runs. would you?
Пікірлер: 15