Hi everyone!
So this is the final part of my "Commando" build series from Halo Reach. I'm redoing some of the sanding by trying out glazing spot putty, wet sanding, and finally getting to the weathering! It's been a fun two months working on this, but I'm very satisfied with the final look. I thank all of you who have been keeping up with this! Please let me know what other helmets you'd like to see in the near future in the comments below!
Here is the link to the shop I purchased the model from: www.aguilarworkshop.com/produ...
3D Printers I use - CR-10 V3 - amzn.to/3CcfxG2
Print Settings
-0.6mm nozzle
-3 layer walls
-15% density
-7% support density
-75 mm/s speed
Tools Used:
_____________________________________________
-Milwaukee M12 Detail Sander - amzn.to/3I3uayY
-Filler Primer (Similar to the one I used in video) - amzn.to/3FYIExq
-3M Sanding Blocks - amzn.to/3WJZ5EJ
-Precision Kit - amzn.to/3YRt7bh
-Cutting Pliers - amzn.to/3YTc88P
-RIDGID Detail Vacuum Set - amzn.to/3VoqStm
-Compressed Air Cans ( Air compressor works the same) - amzn.to/3Wsi46T
Camera Gear:
_____________________________________________
Sony A7SIII - amzn.to/3WD8H4g
Sigma 24-70mm - amzn.to/3Gu5ezL
Go Pro Hero 10 - amzn.to/3C2idFY
Негізгі бет Ойындар Building a 3D Printed Helmet From Halo - Commando Finale
Пікірлер: 75