Part 3
At this stage of building the chicken tractor, near the end, I unfortunately ran into several obstacles...
Leveling the egg roll-out compartment wasn't easy either, but we got over it relatively quickly :)
It turned out to be much more difficult than expected, even though I only worked directly with 1 cm OSB sheets. Due to the weight (since it has to be moved) I had to add a wheel in advance, but obviously it should be something that rotates :D
Field swivel wheels that are sold nearby are damn expensive and they are too thin, so I was afraid that they would quickly dig in on open ground, and then Vevor came into question... I was able to buy quite good wheels from them, although I still have doubts about using them in open ground :D
Dimensions: 200*130cm, 120/100cm high.
Under the top of the chassis, 2 meters long, I drilled a 1.6 cm deep groove, so the bottom can be replaced.
In the summer, there would be a 200*125cm steel mesh inside, so they don't get so dirty inside the shed, it's better ventilated, and the manure falls on the land to be cultivated.
For the winter, a 200*125 cm osb sheet is added for better insulation.
_
-
-
-
_
Instagram: / hosssutanya
Tiktok: / hosszutanya
Music by:
Wardruna - Algir
Негізгі бет Building a chicken tractor Part 3
Пікірлер