If you're interested in following me further, feel free to check out my gaming channel: / @lamentersgaol
I decided to try and make a PC water cooling distribution block. I've never done this before, but it turned out pretty good! These things are meant to be just another way of routing water throughout your PC, and you need a CNC machine to make them look good. Here's how I made this one.
CyberDen Systems: / @cyberdensystems
Jojococo Studio: • Modding the Corsair Ca...
Water cooling fittings are usually size G1/4. I cut a hole that was 11.8mm diameter and tapped it with a G1/4 size tap. I put a 2mm gap between the O-ring channel and the water channel, and the O-ring channel is 3.2mm wide and 2.2mm deep, with a 3mm O-ring. I spaced the screws about 1 inch apart, and the diameter of the screw holes was 3.7mm wide for the tap and 8mm wide for the head. The tap was a size M4x.07mm and the screws were size M4 10mm. The tools and hardware I used are linked below!
Tools and materials! (Affiliate links)
M4 10mm screws: amzn.to/2JRwEPY
3mm O-ring cord: amzn.to/2tfwA5J
Loctite 406: amzn.to/2Mypoug
2' square 1/4" thick acrylic: amzn.to/2MwkmOY
2' square 1/2" thick acrylic: amzn.to/2MyboR3
M4x0.7mm tap: amzn.to/2LYVU7A
tap handle: amzn.to/2Mwpx1f
G1/4 tap: amzn.to/2lcE9q7
CNC machine: carbide3d.com/s...
Fusion 360: www.autodesk.c...
My socials! If you want to see updates between videos, this is how
/ dietecmods
/ dietecmods
/ dietecmods
/ dietecmods
www.dietecmods...
Discord chat: / discord
For business inquiries:dietecmods@gmail.com
Негізгі бет Building a watercooling distribution block
Пікірлер: 305