In this video I will show you how to create a button box that is used in games. Using zero delay encoder board. Also, I will show you how to have 16 buttons instead of 12.
In addition to the parts you also need a drill, drill bits, soldering iron, solder wire, and wires to connecting the buttons to board (I used the standard ethernet cable).
P.S. I have 19 buttons on the box, which 3 of them are not connected, I designed like that because I was planning to use Arduino pro micro.
Buttons Box design: bit.ly/3TlvMaA
Parts:
Note: I am providing the link that I bought the parts from, you are free to use them or not.
Plastic electrical project box: www.amazon.com...
4 position momentary joystick switch (HKD-FW24):
www.amazon.com...
Calterm push-pull switch (Calterm 42200 ):
www.amazon.com...
Waterproof momentary push button normal open (PBS-33B):
www.amazon.com...
Car engine start push button:
www.amazon.com...
Mini momentary toggle switch 3 position on/off/on (MTS-123):
www.amazon.com...
Zero delay encoder board:
www.amazon.com...
3D matte carbon fiber wrap:
www.ebay.com/i...
Soldering iron:
www.amazon.com...
Wires (I used standard ethernet cable):
www.amazon.com...
Drill bit:
www.amazon.com...
Facebook: / baldeaglegamingpage
Instagram: / baldeagle_gaming
Video music: www.mixkit.co
Негізгі бет Building button box with 16 buttons using zero delay encoder board
No video
Пікірлер: 36