Welcome to episode 7, "The Glue-Up!" This may not be the most exciting of the series but it is the last step before flipping the whole bench right-side up. If you are into half-laps, mortise and tenon, and draw-boring with dowels then this is the video for you. Thanks for watching! As always, subscribing, comments and questions are always appreciated.
As requested, here is a link to the linear bearing and steel rod that I will be using with my leg vise.
30mm Linear Bearing - amzn.to/2Eb731d
30x500mm Steel Shaft - amzn.to/2CG0Aym
The 30mm shaft can be a bit problematic to find so some Internet searching my be necessary. They also can be purchased on eBay from time to time.
Негізгі бет Building My Roubo Workbench Part 7
Пікірлер: 7