Used this on batteries that are immersed in water on model submarines for years with out any problems, good stuff !
@antdx316
10 жыл бұрын
that's a good way to trap the heat in and make it overheat
@RCcarRookie
10 жыл бұрын
Ranger another thing you can do is check each individual cell to see if, it's giving you the total load of voltage it's supposed to. If you don't already have it go to a hobby shop and get the cell tester it's like 5.00-10.00 bucks. If your battery has external damage (not extreme) but you have the voltage capacity evenly distributed through the battery you should be good to go. Good luck
@soheilgolgolchin6161
3 жыл бұрын
hi,thanks for the informative video, i wonder if it causes them to overheat? have you experienced any problem with overheating?
@saschapreu9360
8 жыл бұрын
Thanks I have puzzeld for a while that I should have done. That video helped me a lot
@anelkogalic2387
9 жыл бұрын
Thanks for the great video ... Advanced've shown how to protect each Rc
@RCproductions2015
10 жыл бұрын
Awesome videos, I subbed and keep the great videos coming
@HaloCOD816
11 жыл бұрын
Great video I don't know how u dont have more subs
@Diedonacagedworld
10 жыл бұрын
hey the original heatshrink that is on my battery has a few cuts and tears and I see moisture in it. can I remove the clear shrink wrap on it and then use the black tape and then the plastic dip? these arent lipo though; im just starting out; there venon 4200 batteries
@kanarimentos7056
10 жыл бұрын
..hi thanks for the video i do have question i do have quad copter with battery 350mah with wall power i ido have other battery from store i use the same charge it puff or burn why but the same but different company and what does battery hase protect thanks
@aguilarsergio4323
7 жыл бұрын
Nice
@briancv83
8 жыл бұрын
use hull tape for boats.. or aka hockey tape. waaaay stickier than electrical tape. even sticks to wet surfaces. check it out.
@briancv83
8 жыл бұрын
for rc boats**
@alexanderdepauw7939
9 жыл бұрын
Isn't this causing overheating issues?
@JoaoPauloCorrea
11 жыл бұрын
hi, what is the name of hi temp disc brake ? thanks.
@manilaicecream625
10 жыл бұрын
I fell asleep. This could have been shot in 4 minutes. Nice work either way.
@fournier1592
11 жыл бұрын
will it heat up more?
@jnagime
11 жыл бұрын
The tape its not enough to waterproof?
@b323ss2
8 жыл бұрын
Do you need to do this with a hardcase lipo?
@Tylerfromtjstudios
8 жыл бұрын
I would like to know too
@damianmarkle3406
10 жыл бұрын
24$ for that?? i just bought the 8$ can and sprayed
@TheAdminFromHell
9 жыл бұрын
store your plastidip upside down, keeps the dip from drying on the top part of the can.
@TheAdminFromHell
9 жыл бұрын
also, dip your shit, stop using that brush.
@michaeldev5962
4 жыл бұрын
You sound like Forrest 😅
@thebajanmexican
11 жыл бұрын
can i just put the whole battery in the plastidip
@MrDREIK
6 жыл бұрын
sorry bat compression battery verry risk in case di exsplosion, the fabric prevision exsplosion battery over charger is not compresion material verry difficolt exit gas and possible big exsplosion, use one material plastidip no scothc
@alexluka9521
7 жыл бұрын
Battery don't need to be waterproofed
@JEmmCitizen650
9 жыл бұрын
wear gloves on yo next video .and did u say yo old lady is in to this shit...??? i hope not at any rate good looking out thx fo sharing
Пікірлер: 33