Decent solution. Might not have that "spatious clean look" but it sure tidies everything up nicely.
@dsbdnet
2 жыл бұрын
bus bar ordered. thanks again Alan!
@Uraljunkie
2 жыл бұрын
Sweet! Enjoy and thanks for watching! One note… the hole for the battery bolt is larger than the bolt itself. That turns out to be a good thing so you can move the busbar outward (from the center) to eliminate any contact between the positive busbar and the battery strap.
@epicridesandtours
8 ай бұрын
Nice idea, mate. I've just wired in a dual battery system on our 2011 Tourist. I was thinking there are too many wires terminating on the battery, and this might be what I'm looking for.
@Uraljunkie
8 ай бұрын
Seems to be working fine. A lot easier taking out and putting back in the battery too.
@epicridesandtours
8 ай бұрын
@@Uraljunkie Certainly does look easier, as well as tidier. I've located a supplier, but will have to wait a bit, as we're off on a road trip. (1,170 km each way = 730 miles each way).
@Uraljunkie
8 ай бұрын
Sweet - have fun. I got mine from Amazon. www.amazon.com/gp/product/B00T59OLQQ/
@MarkKratzMC
2 жыл бұрын
Right now I’m trying to figure out what is going on with my dealer installed side car aux lights. The circuit seems fine so I think it’s the handlebar switch. I’m also going to install a spotlight.
@Uraljunkie
2 жыл бұрын
Good luck with the switch. Let me know how the spotlight goes… I have always thought about one too…
@MarkKratzMC
2 жыл бұрын
@@Uraljunkie I bought some military grade spotlights from eBay. They have strong magnetic bases and are a fraction of the cost for the Ural factory ones. You can always upgrade the bulbs
@frankdillon6127
2 жыл бұрын
never seen a red positive cap like that ever fit properly. only good to locate the pos treminal.
@markhendricks5894
2 жыл бұрын
Allen, Where are the 4 circuits on the positive terminal fused at?
@Uraljunkie
2 жыл бұрын
Hi Mark - they all have inline fuses.
@markhendricks5894
2 жыл бұрын
@@Uraljunkie I thought so but wanted to make sure.
@kengalts7064
2 жыл бұрын
cool
@Googlag
2 жыл бұрын
Hello old man! Biting off the ring heads and clamping is not the best idea. . If it came to that radically, I would buy a moisture-proof contactor and just put the necessary wires into it. And you forgot to treat it with silicone or varnish . They will oxidize.
@Uraljunkie
2 жыл бұрын
Hey there! I am just evaluating it to see if the whole thing will loosen up. The screws have star washers on them, so even the clipped terminals should stay tight. Thanks for the comment!
Пікірлер: 19