it looks like the center piece is 1/4 holding the coil over and 3/16 material back plate ?
@JoeA-u5v
Жыл бұрын
SI ESTA BIEN ESA SUSPENSION LO QUE TE FALTO DEPERDIDO VER PINTADO LO QUE SE ISTALO USADO USADO SI MIRARIA MUCHO MEJOR
@CRXSLY
3 жыл бұрын
got the same front kit from QA1 with 750lbs spring (mine got a 6L LS) just love it! combine with a Borgeson 12:7 quick ratio steering box now iv got a truck drive like a racer loll keep on the good work!
@charliesgarage6447
3 жыл бұрын
Nice! Yeah I’m behind in editing and have the truck up and going and it drives like it’s on rails
@meza5207
8 ай бұрын
What year spindle did you use ? I have a 70 c10
@NextEraCustoms
Жыл бұрын
nice kit would you know what size material is the upper bracket that holds the coil over that came in the kit is it 3/16 or 1/4 material QA1 uses ? looks good sir.
@charliesgarage6447
Жыл бұрын
I don’t remember off the top of my head since it’s been a while but I think it was 1/4. It’s definitely beefier then factory.
@NextEraCustoms
Жыл бұрын
@@charliesgarage6447 its looks like 3/16 i am asking because i am fabricating something similar and i don't know what size to make them out off can u measure it later and let me know ?
Пікірлер: 15