My MCPX v2 brushed motor project was a no-go. The 1S power supply was insuffcient. The tail rotor needs 2S too.
SO, moving on I stripped the frame assembly back down and am now fitting it with motor and control board from a 2S -powered MCPX BL.
I still have to figure out what to use for a brushless tail motor, since MCPX BL tail motors are extremely rare and near impossible to find. The stock one is a 8mm diameter 2-pole inrunner. I have seen replacement outrunners, but their high pole count means they will not spin as fast with the same input from the stock MCPX BL board, so dunno yet.
This is my first run-up with main blades attached. Note I had to enlarge the vent opening in the roof to clear the motor and wires.
Негізгі бет C186 - MCPX BL Motor and Control Board.
Пікірлер: 8