Holy moly! Did the previous owner just have the neighbors 10 year old kids do the first installation? Carvana would be giving me a refund or paying for the repair for that mess! 🤯🤯🤯🤯🤯
@camrynflores8041
Жыл бұрын
How much would something like this cost? Parts and labor
@adhd8736
7 ай бұрын
just an odd question is but connectors a bad connector to use for this kind of wiring because that’s on of the main connectors i do use and i would love the pros opinion
@JMarcotte1
Жыл бұрын
Dang, how about a trigger warning first. lol
@davidbkk171
Ай бұрын
Why didnt you use the factory mic? I did. then you dont have to use that ugly clip mike just connect a 3.5mm male audio connector tot he factory mic works like a carm
@jake0869
2 ай бұрын
Just bought a c6 z06 and it's in the same situation, if not worse than this, since the previous owner had a whole LED system installed as well. Its been giving me a massive headache.
@jrbird7571
Жыл бұрын
Uhhhggg ...... my GOD! That poor C6.
@janjohansson3855
Жыл бұрын
When you cut an OEM cable harness, it should automatically be 10 years of hard work in a Russian Gulag, You should NEVER cut in OEM cable harness, If you don't know what you do don't do it.
@lanebarker297
7 ай бұрын
I've noticed EVERY audio installer is SCARRED SH!TLESS of a soldering iron !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
@marksiegel374
Жыл бұрын
Wow,,lots of work..Carvana I hope helped this guy out with cost...Nice work..
@drking3000
5 ай бұрын
This is an example of what happens when you "know a guy" that does it for cheap.
@m.a.saudio9667
Жыл бұрын
Probably 1 of my easiest install I have done if done right.had to re wire a c6 a audio shop did it just like this 1 but ran wires from the amp back to the cd player just cause they didn't wanna run the wire threw the doors and replace the factory speakers 🤦🏾♂️🤦🏾♂️shit was a nightmare
@davidnclearlaketx
Жыл бұрын
The device that you're talking about near the dash speaker is a photoresistor not a potentiometer. A potentiometer is a variable resistor with a shaft and a knob (or a PC board mounted miniature pot that can be adjusted with a small screwdriver) that you can adjust it manually. The photoresistor changes its resistance by light hitting the sensor and changing the resistance value in correlation with the amount of light being detected. Good video though! Excellent mod for the Bluetooth microphone using the OEM location! 👍😊
@engelengle8281
9 ай бұрын
Which amp did you use?
@octanetvchannel
9 ай бұрын
Audio dynamics. If you would like to get one let us know we can help you with that
Пікірлер: 18