In this video chronicling my CNC Plasma build, we mount the cable track and run enough cables to finally put the machine into motion.
The cable track I sources is a little too small but I will make it work. I roughed in the motor and e-stop cables using 4 conductor 18awg shielded cable. The end result is a machine that moves smooth and precise as least to the point a plasma table needs smooth and precise.
If you are interested in a set of transfer punches, here’s an affiliate link to where else, but Amazon.
amzn.to/303byKC
I hope to get the next video out on this topic is less time than it took to do this one. I have not completed the machine yet so you haven’t missed the first cuts. That will be coming this winter.
~P.
Web site: sbirdranch.com
Amazon: www.amazon.com/shop/sbirdranch
Негізгі бет Тәжірибелік нұсқаулар және стиль Cable Tracks and First Jog
Пікірлер: 34