Cablofil has a range of horizontal bend solutions, designed to save you minutes on every install.
Horizontal bend with SWK: When forming sweeps, alternating sections of side and bottom wires are removed so that the open area creates clearance for the sweep. Once these are removed, the bend or sweep can be formed. Use SWK hardware to secure the sweep.
Horizontal bend with EZT90: For cutting steps, follow the installation guide for an EZT90 bend. After cutting, form the bend; use an EZT90 kit to secure the bend.
Cablobend: Cablobend’s premade sections arrive fully assembled. Simply stretch each outside bend wire approximately 3 ½ inches, attach retaining clips on the inside radius by simply snapping them on.
Негізгі бет Cablofil Productivity Saving Solutions: Horizontal Bends
Пікірлер