Love seeing cold starts like this... from the drivers side looking in so we can see the startup procedure. Please make more of these!
@kenbradley5228
7 жыл бұрын
love what you are doing, would like to know more about the engine.
@jonboy545
7 жыл бұрын
Ken Bradley HI Ken, this is my brother in law's project. If memory serves me correctly it's an iron block LS2, fully built bottom end. Forged rods, crank, pistons, etc. Don't know the cam specs. At the time of this video it was running on a mail order tune to get it running. It has since been dyno tuned. The turbo on there at the time of the video was out of a semi truck. It leaked oil badly, now has a borg warner turbo but don't remember the specs. 70ish mm I think. Put down about 650HP on a very conservative 14lbs of boost. Motor and turbo has ALOT left in it. Check my channel, I just filmed a ride along in it with a couple WOT pulls.
Пікірлер: 6