This was so helpful. Thank you for making this video
@fishnitup
7 ай бұрын
You're so welcome!
@jonathandavis5733
6 ай бұрын
Question, I am trying to do this however after clicking begin and turning the boat the progress bar just stays at 0... I have done this before and the progress bar moved but never completed successfully. Now it doesn't even attempt to start progressing. I have reset the sonar to default and tried again. Still no progress on the progress bar. any suggestions? thanks Jonathan
@fishnitup
6 ай бұрын
Where is the transducer mounted?
@PMantle
2 ай бұрын
Same thing is happening to me. Going to try disconnecting the network cable next.
@robertdecristofaro8481
8 ай бұрын
Should I calibrate on a pole-mounted LVS 34?
@fishnitup
8 ай бұрын
My understanding of how the calibration works I would say yes. It stabilizes the transducer beam so that it's aligned correctly with the bottom and the boat. It ensures the bottom is correctly oriented. Without it being calibrated the bottom could look steeper or flatter than it really is. Hope that helps.
@owlsnestoutdoors
5 ай бұрын
In case you go out before me. This video shows how to do it
@benconolly4163
3 ай бұрын
Why didn’t you just drive it with the TM?
@fishnitup
3 ай бұрын
I have done it both ways. I got higher percentages and a more accurate icon orientation when doing it that way. If you use the trolling motor it is turned perpendicular to the boat when you are calibrating it. My on screen icon was never close when doing this.
Пікірлер: 10