This video shows how to calibrate the auto focus for the fusion pro edge and maker CO2 laser only.
If you have a dual source, you’ll have an extra step calibrating the fiber focus .
* Manual Focus Gauge * (Adjustment)
If you need to adjust the gauge, you'll twist the 2 brass fittings apart and twist those parts UP or DOWN; so that when you rest the gauge on the lens assembly it barley touches the material after it's been tested for the brightest spot of engraving.
OWNER'S MANUAL LINK BELOW:
For more information about Auto Focus Calibration, see “Calibrating the Auto Focus”
For more information about the Manual Focus gauge, see “Manual Focus”.
For more information about the touchscreen Auto Focus option, see “Auto Focus”.
For information on focusing a Dual Source job, see “Focusing a Dual Source Job” .
www.epiloglaser.com/assets/do...
SECTION 8: SYSTEM FEATURES
Auto Focus vs Manual Focus In order to engrave or cut a crisp, clean image, your material must be the correct distance from the bottom of the focus lens. Setting the distance from the bottom of the focus lens to the top of your material is the process of focusing, and is accomplished by placing your material on the table and moving the table up or down.
Dashboard Settings Auto Focus Select Auto Focus when you want to use the machine’s Auto Focus capabilities.
You can choose between Thickness, Plunger or Off.
Thickness For the Thickness option, measure the thickness of the material you are using to engrave or cut, and input the number into the Thickness box under each individual process. The table will automatically move up or down so that the top of your material is the correct distance from the bottom of the focus lens, right before running the job.
Plunger When a job is set to the Plunger option, the plunger will measure the focus distance at the first place on the job that the laser will fire. The table will automatically move up or down so that the top of your material is the correct distance from the bottom of the focus lens.
Off This is the default option for Auto Focus. If “Off” is selected, the table will not move up or down when the job starts. When set to “Off”, you must use another method of focusing, since the table must be in focus before running a job.
You may also focus the table using the Manual Focus Gauge or the Auto Focus button on the machine’s touchscreen.
Негізгі бет Тәжірибелік нұсқаулар және стиль Calibration of auto focus on the Epilog Laser Fusion Pro, Edge & Maker (Co2 only)
Пікірлер