I'm getting this 3D printed to shit test where the weak points will be. Our specs right now will be the following when we make the metal version:
4" C Channel - 3 pieces 4" long attached like you see in my mock up. 1/2" thick. Flanges 1.5" with supports on both sides, no back. One support (on the front) will be removable if I desire to test cams not positioned correctly and I'm not pulling too hard. This will fit up to a #4 C4 and will use C Clamp swivel ends on the bolts that adjust the free floating 1/2" plates inside that are able to slide back and forth via the groove plasma cut out of the top. Welding some giant files to the face of each plate should give us enough knurl to keep the cams from sliding.
Always open to more thoughts!
👉 Learn and SHOP at www.hownot2.com/
👉 Best EMAILS on Earth: www.hownot2.co...
👉 10% off ROCKY TALKIE by clicking www.hownot2.co...
Негізгі бет Cam crusher final CAD design (Cardboard and Ducktape)
Пікірлер: 11