Such an informative step by step video with the right detail, going to use this when I degree in a new cam. Keep 'em coming!
@blueovaldude
3 жыл бұрын
Thank you , glad i could help out .
@blueovaldude
4 жыл бұрын
When you Check your ICL , measure direct from the lifter . As you can see i use a lifter and pushrod and put my dial indicator in the pushrod hole . (Make it a straight shot) . Unlike checking piston to valve clearance where you measure from the retainer to get actual valve lift numbers .
@rueridge7597
2 жыл бұрын
You went with roller cam. I don’t see dog bones other stuff normally used. Do connected lifters not need hold downs other than push rods working in pairs??
@blueovaldude
2 жыл бұрын
Yes , link bar lifters don't need anything else to work, the link bar just has to keep them from turning in the bore . Spider and dog bone style lifters are for use with stock style compatible hydraulic roller cams only . Hope that helps.
@rueridge7597
2 жыл бұрын
@@blueovaldude I have 1990 302 Bronco. Want to upgrade cam/heads. Blocks then were cast for rollers but they used flat hydraulic in truck engines and rollers in Mustang others. Conversion kits abound. Only problem is you have to drill 2 holes in valley to secure spider. I didn’t want to get into lower end now so shavings are no no. Will check with Crower I guess.
@blueovaldude
2 жыл бұрын
@@rueridge7597 you could check the valley of the block and cross your fingers, it is possible to be a roller block . If not ,you could use link bar hydraulic roller lifters . A pile of companies make them and also a proper roller cam .
@daltonk52
2 жыл бұрын
@@blueovaldude my 86 f150 has threads in the center of the block for bolts to go in in the valley would mine be a roller block?
@blueovaldude
2 жыл бұрын
@@daltonk52 It sounds like you have a roller block. You would have 2 raised bosses with threads in the bottom of the lifter valley. You would need the hold down spider, stock style dog bones, stock style roller lifters and compatible camshaft. You should be good to go then. ✌
Пікірлер: 10