You guys did great and just to give some ideas to sleep on…The block you can put a nice coating of JB weld on the ruff spots and make it a nice surface for the gasket. I had an 8N Ford that had a burnt out manifold gasket and the block was also burnt away so I ordered a new gasket and manifold , then mixed up some JB high temp and applied it While it was still somewhat pliable I put the gasket on then the manifold I torqued it down until I saw just a little JB squeeze out and then waited a few hours and torqued it all the way and it held up quite nicely and as you well know gasket maker covers a multitude of sins . And drilling out the one stud is better than drilling out 3 so carry on and what a excellent learning experience for Grumpy Apprentice you don’t get experience like this in a classroom or always buying new or talking it to the local shop and spending more than the tractor is worth so just keep at it 😀🇨🇦
@stevemccoy8138
23 сағат бұрын
Dang it, you will get it done. That bolt is really stuck. Good Luck. 😊
Пікірлер