Thank you for all the amazing content. I am in the process of doing the 22w upgrade to my S10, and I was wondering what filament you used for the adapter plate. I was going to go with ABS but thought perhaps PETG. How has the adapter plate been holding up long term? Thanks in advance, and keep posting great videos!
@manuelaquino7587
11 ай бұрын
Thank you, excellent effort
@ericdekeersmaeker5780
8 ай бұрын
When you double your speed and add an extra pass, you will get cleaner cuts/edges.
@thaDon2525
10 ай бұрын
Good Video, thanks . Iv an s10 , what way did you wire in your old air assist to work with lightburn ? Iv a large compressor so would just be looking to trigger a solenoid valve to open and close .
@blazprsa
6 ай бұрын
i have an extention 900x900 for s10, and the s10 module .. if i replace it with 22w module i have to change only the attachment plate or there is something else to change ?? thank u ;)
@Alves711
Ай бұрын
o vídeo em Português não há?
@ericdekeersmaeker5780
8 ай бұрын
You could have prevented the broken connector by fixing the wire better. It shouldn’t move at all during lasering.
@ericdekeersmaeker5780
8 ай бұрын
And that goes for the 22w too. Fix it on two places on the frame
Пікірлер: 8