CanAm angle finishers - Instructions
After you've mixed your drywall mud, laid tapes into the angles and rolled them tightly into the corner.
Grab your can-am pole. It should have the gooseneck and ball socket on the end.
For wiping tapes, snap-on the 2 1/2" flusher.
Check that it pivots easily, the wheels spin, feathering edges are sharp
To start, wipe a small amount of mud onto the face of the flusher.
This is going to help slide and fill out the tapes.
Square up to the angle, bend down and lift up.
Touch-up and straighten the bottom of the tapes.
When dry, use a compound tube and applicator to add mud.
Use your legs to squat down. Move yourself to be in the center of the angle.
Position the gooseneck in the center of the flushers socket and center of the angle.
Wipe with steady speed and pressure, turning the gooseneck and pole as needed.
Use water and a scrubber to get off the mud.
The 2 1/2" angle head for tapes.
3" finisher and
3 1/2" finishers can be used for coating tapes
Nycor 2 1/2" 3" and 3 1/2" angle flushers
Should be used in the same order, and have quick pole adaptors or use by hand.
Some angle heads ca fit onto the compound tube, see video for instructions.
The mud flows out of the Variable Flow Cover Plate.
The Nycor angle heads snap-on to the compound tube too and mud flows out of this hole.
Thoroughly cleaning, and checking every part of the angle finishers assures perfect finishing.
Washing your canam tools right after use is easiest and keeps them working the best.
Негізгі бет Ғылым және технология CANAM Angle Finisher
Пікірлер