Constant vacuum boils moisture. Lay a tarp over the inside of hull to kinda seal it up and put a vacuum pump on it for quite a while.
@seangreene64
3 жыл бұрын
Sounds like you need to cut the deck and replace the foam. Get it done
@rollingrecords9019
6 ай бұрын
My guy made a turbine garbage can heck yah brother 💯
@MrVanTeacher
9 ай бұрын
maybe vacuuming from the garman holes with a dehumidifier under a sealed/covered top.... that might work even better.... maybe? excellent vid👍👍
@Beachnative42
3 жыл бұрын
where ever there is a hole in the deck is a wet cell. Cut the floor out and remove the wet foam and reglass. Each wet cell can be up to one cubic foot. One cubic foot = 7.48 gallons. 7.48 times the weight of a gallon of water (8.33) = 62.3 Pounds if completely full of water per cell. Im counting at least 10 cells with holes in them meaning up to 623 pounds of water are in there. To those that say it's no big deal do the math.
@stacyzimmerman6212
2 жыл бұрын
is there info on how to do this?
@lgallant
4 жыл бұрын
Doing the same to my little 13' whaler over in Greer. Hope to get back to shrimping this fall as well!
@joeyogston4421
4 жыл бұрын
Nothing to it but to do it. Good luck.
@mattmobley9671
3 жыл бұрын
cover the boat tightly and run a dehumidifier under the cover for a couple of weeks.
@trialsrider172
3 жыл бұрын
Any update on if you got your boat to plane? Seems about the best way to dry it up, curious if it worked for you
@joeyogston4421
3 жыл бұрын
Carolina Skiff gets on plane easy now. I occasionally pull the garboard drain plugs and check for a dry hull. So far so good.
@trialsrider172
3 жыл бұрын
@@joeyogston4421 thanks for the reply! I am in the midst of a deal on one with the same problem. Not looking to make it perfect just usable so I figured if you made some improvement doing it this way it would be worth trying
Пікірлер: 15