This is the fourth part to me trying to document and fix the broke 3 point lift on our Case 885. Most of the winter I stored the valve body and related parts with penetrating fluid, ATF, diesel, either, etc in an attempt to get the valves inside to break free. I mainly used a wooden dowel rod and tried my best to get it to grab but to no avail.
After some discussion over at the DBTC forums someone recommended a concrete anchor bolt. in combination with hitting the valves fairly hard with the wooden dowel, the soaking over the winter and then using the "extractor" I was finally successful!
The other videos can be seen here in the playlist:
• Casey 885
Sorry about the lack of editing, Slow internet makes it not quite as much fun.
I created this video with the KZitem Video Editor ( / editor )
Негізгі бет Case 885 Removing Hydraulic Control Valve 4
Пікірлер: 37