I have fond memories of these old tractors. it was what I learned to drive on . I liked it so much that I sat behind the wheel for 28,000 hours and the engine had never been touched since it left the factory.
@charleswelch249
5 ай бұрын
Great content and I have the same tractor in the same condition. So the more I can learn the better I can restore mine. Thanks for sharing your experience with us all.
@colmanlong1032
2 жыл бұрын
Great job you done there.
@tcmits3699
Жыл бұрын
Got lucky pressing that bearing out, plates or large tube should be used as an anvil pressing the water pump shaft out, as close to the bearings od as possible. Those mounting bosses have a tendency to break off. Good luck, and thanks for sharing 👍
@joeamericamontanarian9465
Жыл бұрын
thanks for taking time to make these, helps us with our 1210. what pray tel is that magic blue disk on your die grinder? looks like it does such a nice job. thanks!
@tightwadproductions961
Жыл бұрын
They are strip / clean strip discs. They work great for rust removal without really getting into the base metal.
@claesmansson9070
2 жыл бұрын
Yes of course it took a long time,the engine wasn t working!
@nisse693
2 жыл бұрын
Should ther not be a curtain infront of the raidiator to help the engine varming bether?
@claesmansson9070
2 жыл бұрын
Yes,they can borrow grand mothers gardin and see if it fits !
@josejesusluna2695
Жыл бұрын
O do have one just like et but mine don't work the lifting arms if You can help i apreciate the help
Пікірлер: 11