Thats cruel on that motor, he needs to read the starting instructions, glow plugs for 2 or 3 mins depending on temp then when it fires go back to glow plugs till it runs smooth, no need for all the smoking an knocking going on there.
@johnnoonan5802
8 ай бұрын
What a great starter motor ,, pity the glow plugs arent as good theres alot of diesel in the cylinders there easy to break a con rod , the Cummins starts a bit easier ,, the D 9 g and H are great dozers though
@danielcapo1991
6 ай бұрын
I don’t recommend you use an ether because it can ruin bearings in engine
@RomeKG471
2 жыл бұрын
Get the glow plugs working! Good way to throw a rod!
@ruaraidhmcdonald-walker9524
9 ай бұрын
Or alternatively use the preheat for a minute before cranking as you’re instructed to do….. 🙄
@jimwise4029
Жыл бұрын
Heat with glow plugs for 2 minutes should fire ride up no need for for your can
@NC-xk1eg
5 ай бұрын
I can't believe that the battery had that much juice!
@MailsonJaques
7 ай бұрын
Has it always been like this since the factory starts?
@gearhead9943
2 жыл бұрын
Please make more of these but next time bring us closer so we can watch what you do with the controls and pedals while starting it
@ColtWR
2 жыл бұрын
Will do
@chrismurnane6389
10 ай бұрын
Piolet motor is the ONLY WAY in my obstinate option 😊
@austinshackles549
6 күн бұрын
Only the old ones had pony motors, I think. Newer ones are electric start. I had a diesel van once that took 90 seconds of preheat to start in cold weather, any less it wouldn't fire.
@skanti-sp2qz
4 ай бұрын
Bet the valve clearances are way out of spec.
@shanemurphy2680
Жыл бұрын
I've got a fiat allis fd40 touch the starter putting and it off,runs so smooth ,cummins kta19,there prehistoric cat engines when they eventually Start are so dam rough
@jimwise4029
Жыл бұрын
Might start good but how long does it run before it throws a final drive
@franko3792
10 ай бұрын
Pull the choke lever
@waldotrueb6081
9 ай бұрын
More choke !
@unclejoe7929
2 ай бұрын
No one ever taught him how to use ether properly. If I saw him do this to one of my machines it would be the last time he ever sat in one. Now if no one has taught him, ok, lesson Number One DON’T do it this way. You spray the ether into the air intake WHILE you are cranking it! NEVER spray and walk away.
@austinshackles549
6 күн бұрын
better yet don't use it at all. If the preheat doesn't work, it's not that hard to fix it. Too many folks just reach for the ether. I guess it's legit if you're trying to start something that's been sitting for 10 years but anything that's run at all regularly ought not to need ether.
@nspro931
5 күн бұрын
@@austinshackles549 What he did on this big motor is no problem at all.
Пікірлер: 21