Nice job! Note at 4:45 if you want to straighten a warped length of steel, heat a pie shaped wedge on the side that needs to be shorter to a red hot and let cool. Do as meany times and locations as needed because this will tend to straighten it.
@hunterscreekfarm95665
10 ай бұрын
Thank you for the tip!! I'll give it a try.
@johnr5545
Жыл бұрын
Nice job I do a lot of the same stuff cool beans God bless
@douglascorley6630
Жыл бұрын
You're going to have to nickname that thing route
@billyhaddock5540
Жыл бұрын
Great Job HCF on building ur own D2 Brush Rake. looks cool. By the way, ur white C10 Chevy Stepside PU Looks Cool Also..
@hunterscreekfarm95665
Жыл бұрын
Thank you!
@bluegrallis
Жыл бұрын
I have been thinking of building something like this for my Oliver OC46. I may not have enough grouser to do a great job at root raking, but I think it would be handy for clearing some of the invasive honeysuckle bush from the hunting pasture. I thought about finding an old scrap chisel plow, and use the shanks and some of the frame from it.
@hunterscreekfarm95665
Жыл бұрын
I am kind of in the same boat with my D2. Not gonna push out any big roots but it should work good for the smaller brush and blow down clean up type work. Share some pictures of your project when you get to it.
@bobber55
Жыл бұрын
Looks pretty good. I suppose you tested the swing and it clears the tractor grill. I believe I would have welded in a cross-member on the expanded metal. As far as the quality of the paint job looks great where I am. I suppose time will tell if that square tubing is heavy enough. The force on it will be outward.
@hunterscreekfarm95665
Жыл бұрын
Yes, the swing should clear the front of the tractor. That's a good point about a crossmember behind the expanded metal. If I end up bending it I will definitely put one in. Thanks
@bobber55
Жыл бұрын
@@hunterscreekfarm95665 I forgot to mention that's an excellent idea on sleeving that hollow tubing for your mount and swing joint. I do the same thing when I'm pinning something through hollow tubing. However, so many times I see a joint like that without it being sleeved.
@aneel156
Жыл бұрын
Who is this “Nice guy from work “ who gave you the threaded rods??!!!! 😂
Пікірлер: 13