The cause of the Honda Beat injection motorcycle turn signal that is totally dead
The first step we have to do is check the output current from the battery after the ignition is on.
Check the battery current after contact is on by using a zip lamp, one end goes into the battery output cable in the plaser, and the other goes to mass, make sure there is current. Then check the pleser output line and make sure it's flashing.
then make sure the current pleser output must reach the socket before entering the cent switch, and make sure it is there. then check the power from the cent switch that leads to the left or right cent, and is parallel to the front and rear turn signal lights. or motorcycle frame. And also make sure the turn signal is good.
Thank you very much to all #SUBSCRIBER#and viewers, hopefully the knowledge is useful.
please # SUBSCRIBE AND LIKE #
#SIDIK NURYADEN CHANNEL#
If you have any questions, you can write them in the comments
Tel/WA: 085863491419.
Thank you very much.
Негізгі бет Автокөліктер мен көлік құралдары Causes of the Honda Beat Injection Motorcycle Sen Light Off Total Not On.
Пікірлер: 175